Kenmore Dishwasher 665.15832000 (66515832000, 665 15832000) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: 8194582
includes seal
Do-It-Yourself Stories from Customers like You
Pump needed replacement cause nut that holds it on melted to the threads. Deborah S. • Lincoln , NE • November 06, 2017
Replaced nut and then found we needed new pump.
Read more
More
$52.33
- Compare At:
-
$62.80
- You Save:
-
$10.47
Genuine Whirlpool part
By: Whirlpool
Part Number: 72032
Bottle with brush. Color: Black. Size: 0.6 fl.oz.
Do-It-Yourself Stories from Customers like You
Leaking diaphragm Herbert S. • Monroe Township , NJ • January 03, 2015
Replaced It With New One
Read more
More
$17.76
- Compare At:
-
$21.13
- You Save:
-
$3.37
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3376397
Included with nut.
Do-It-Yourself Stories from Customers like You
Inadequate cleaning of dishes / detergent residue all over the interior Randy N. • Elkhart , IN • September 19, 2015
I cleaned all the jet nozzles with a toothpick and a pipe cleaner to remove the hard water deposits. I then replace the ring bearing under the bottom spray wand and the ring bearing under the upper spray wand. I also replaced the smaller radial ring bearing. Although none of them looked overly worn, it doesn't take much to cause the spray wands to spray inadequately.
Then, I replaced the float and washer assembly. Although it appeared to work properly when I lifted up on it and let it down, it...
Read more
More
$65.64
- Compare At:
-
$78.11
- You Save:
-
$12.47
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268843
There is a split at the 3 O'clock position. Color: white. It measures about 3 inches wide by 4 inches high.
Do-It-Yourself Stories from Customers like You
The water supply tube to the upper level of the dishwasher broke. While looking for that part, I realized we were missing the feed tube holder Lucia B. • Exeter , ME • June 06, 2020
We had to take the clips off the side arms to remove the upper basket. Then we turned it upside down to easily access the supply tube. There was one screw that held the assembly in place. We removed that and then replaced the part and put it back together. The feed tube holder just clipped to the upper basket.
Read more
More
$42.95
- Compare At:
-
$51.11
- You Save:
-
$8.16
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489069
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
Do-It-Yourself Stories from Customers like You
Broken handle foot pedal and missing parts Donald M. • Lake Arrowhead , CA • April 05, 2015
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy!
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3369505
Detergent cup dispenser actuator assembly.
Do-It-Yourself Stories from Customers like You
Springs detergent releasing pin needed to be replaced Clyde A. • Greenville , SC • October 16, 2025
Received correct parts for Appliance Parts with ease and quickly.
Read more
More
$32.95
- Compare At:
-
$39.21
- You Save:
-
$6.26
Genuine Whirlpool part
By: Whirlpool
Part Number: 4392899
Bottle with brush. Color: Biscuit paint. It's point-six fluid ounces.
Do-It-Yourself Stories from Customers like You
Lack of accurate control on 2 electric range burners Jeff D. • Neenah , WI • April 09, 2016
Ordered 2 infinite burner controls from Appliance Parts Pros and watched the online video on the replacement of them at the same time. When they arrived promptly, I was ready to take on the job.
The fix only took about 15 minutes because I was prepared after watching the video.
Read more
More
$17.76
- Compare At:
-
$21.31
- You Save:
-
$3.55
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10082896
Includes washers.
Do-It-Yourself Stories from Customers like You
Whirlpool dishwasher no drying cycle heat John W. • Crestwood , KY • April 02, 2017
Replacement heater element installed exactly as described in the AppliancePartsPros video.
Read more
More
$75.64
- Compare At:
-
$89.26
- You Save:
-
$13.62
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3374077
Size: 7 foot long.
Do-It-Yourself Stories from Customers like You
Bought a used dishwasher in excellent shape that needed the drain pieces to get it going Johnny R. • San Antonio , TX • April 14, 2015
Bought the parts and connected same...a breeze in finding and receiving and eventually installing these parts.
Read more
More
$62.78
- Compare At:
-
$74.71
- You Save:
-
$11.93
Genuine Whirlpool part
By: Whirlpool
Part Number: 350956
Almond. Size: 13 oz. can. Acrylic appliance paint.
Do-It-Yourself Stories from Customers like You
Age no money to fix it Ronald V. • Cape Coral , FL • August 01, 2015
Was able to match it pretty well the natural age difference was good. The delivery of the product was amazing it took less than 24 hours to get to me and that was standard shipping. Give you guys an A for great !!
Read more
More
$30.52
- Compare At:
-
$36.32
- You Save:
-
$5.80
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10348413
This replacement screw secures appliance panels and components so they stay tight and aligned. Replace a missing, rusty, or stripped fastener to restore a solid hold and reduce vibration or rattling during operation. What it does:
- Fastens and secures panels, brackets, trim, or internal components as specified for your model
- Replaces missing, corroded, or stripped hardware to restore a proper fit
- Helps prevent vibration, rattling, and misalignment caused by loose fasteners
- Addresses issues like a loose panel/handle or a screw head that's rounded off
What's included:
Install notes:
- Disconnect power; if applicable, shut off gas and water before servicing
- Use the correct driver size; start by hand to avoid cross-threading
- Tighten snugly—do not overtighten into plastic or thin sheet metal
- Keep track of original screw locations and lengths during reassembly
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP719929
This small check ball sits inside a check valve to allow one-way water flow. Replacing a worn or missing ball helps prevent backflow and supports reliable draining performance between cycles.
- Maintains one-way flow through the valve to stop water from returning after the pump stops
- Helps ensure complete, consistent draining
- A damaged, swollen, or missing ball can let water back up into the tub/sump
- Contribute to slow or intermittent draining and unusual gurgling/flow noises
What's included: 1 check ball. Install notes:
- Disconnect power and shut off water before servicing
- Access the check valve assembly per your model's service information (commonly at the sump, pump outlet, or drain connection)
- Clean the valve seat/passage; remove debris that could prevent sealing
- Place the ball in the valve seat as shown in your model's parts diagram; reassemble and test for leaks and proper flow
Do-It-Yourself Stories from Customers like You
Dishwasher didn't drain Frank C. • Mcallen , TX • June 02, 2016
Cleared out trash from pump.
Made E-Z by your exploded views and videos. Replaced worn parts.
Read more
More
$6.95
- Compare At:
-
$8.34
- You Save:
-
$1.39
Genuine Whirlpool part
By: Whirlpool
Part Number: WP72107
Color: Almond
Do-It-Yourself Stories from Customers like You
Broken meat drawer Jesse B. • Stow , MA • January 26, 2015
Replaced. Shippping was very fast. A good experience.
Read more
More
$14.95
- Compare At:
-
$17.79
- You Save:
-
$2.84
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268840
This is the upper spray arm that distributes wash water to the top rack. Replacing a cracked, warped, or clogged arm restores even spray coverage and helps the arm spin freely so glasses and bowls come out consistently clean.
- Directs high-pressure jets to the upper rack and rotates under water pressure for full coverage
- Maintains even water distribution to improve cleaning performance
- Common symptoms of a failed arm: top-rack items not getting clean, arm not spinning, uneven spray, cracks or clogged nozzles
What's included: 1 upper spray arm
- Disconnect power and water supply before servicing the dishwasher
- Remove or lower the upper rack if needed; release the retaining nut/clip and pull the old arm straight off
- Seat the new arm fully on the hub/manifold and secure the retainer; verify it spins freely
- Run a short test cycle to ensure proper spray and operation
Do-It-Yourself Stories from Customers like You
Cracked upper spray arm mount Jean M. • Nashville , TN • March 01, 2016
Removed the broken part, found and ordered the replacements on your website, received them in 2 days, put the laptop on the kitchen counter, followed the video that was attached to the parts on your website, spent 15 minutes on the entire repair.
Didn't take the day off work to meet a repairman ($$), diagnosed my own problem, ($$), ordered the parts and didn't pay markup ($$), made my own repair ($$). Then I went around and told all the other ladies in my Moms group that I repaired my own...
Read more
More
$43.95
- Compare At:
-
$52.30
- You Save:
-
$8.35
Genuine Whirlpool part
By: Whirlpool
Part Number: 8193716
This adjustable leveling leg threads into the appliance base to set height and stabilize the cabinet. Replacing a worn or missing leg helps stop rocking and vibration and helps maintain proper alignment for reliable operation.
- Provides adjustable support at one corner of the appliance
- Helps level the unit for correct alignment with floor or cabinetry
- Reduces rocking, vibration, and rattling noises
- Replaces stripped, bent, cracked, or missing leg
What's included: 1 adjustable leveling leg Install notes:
- Disconnect power and, if applicable, shut off water before servicing
- Carefully support or brace the appliance to access the base safely
- Start the new leg by hand to avoid cross-threading; adjust height gradually
- Use a level to check side-to-side and front-to-back, then recheck after positioning
More
$43.95
- Compare At:
-
$52.30
- You Save:
-
$8.35
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3400892
Replacement 8-32-thread screw used to secure panels, brackets and small components in compatible household appliances. Restores missing or stripped fasteners so panels and parts stay firmly attached during normal use. What it does:
- Secures trim, panels, brackets and control housings to maintain proper assembly.
- Replaces missing or damaged screws that can cause rattling, loose panels or misaligned components.
- Fits locations that require an 8-32 threaded fastener; correct length and head style for your application.
- Helps restore stable, vibration-free operation when worn or stripped fasteners are replaced.
What's included: One screw. Install notes:
- Disconnect power and water before servicing; wear eye protection and gloves.
- Use the correct screwdriver or driver bit to avoid stripping the screw head.
- Do not overtighten—turn until snug and secure to avoid damaging threads or surrounding parts.
- If the original used a washer or nut, reuse or replace as needed and the screw length and head type match the original.
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07