Kenmore Dishwasher 665.15973991 (66515973991, 665 15973991) Parts

Replaced the drain & wash impeller kit. Read more

1. To fix the leaks from around the door, I replaced the upper and lower door seals. These were purchased in a separate transcation, so they are not the parts shown here. The upper door seal worked as intended, but the lower seal would not stay in place on the lower edge of the door during a wash. Therefore I cleaned the grease and detergent off the old seal, and installed using silicone sealer/adhesive. The plastic edge pieces for the lower seal were supplied with the kit, and they installed... Read more

Ordered parts from appliance parts pros Read more

I had no hope of separating the panel from the frame without damaging the frame since the two parts were rusted pretty badly and the screws holding the panel to the frame were completely beyond salvage. So I had to replace both the panel and the frame. I ended up removing the electrical/electronic connections, removing the panel/frame from the hinge and then replacing it with the new parts. Took about 90 minutes but the hardest part was removing other items from the rusting frame without... Read more

• Will not agitate

Ordered the parts from AppliancePartsPros - super fast shipping, and even though I opted for regular shipping all of my parts arrived the very next day, including the big and bulky inner basket. Disassembly went smoothly, simply following the directions in the AppliancePartsPros video. The only problem I had was that the inner basket simply would NOT come of the drive block no matter what I did. Struggled for a few hours trying to take it off. Then, I called AppliancePartsPros and they said it... Read more

I did some research online and figured out that I needed to replace the control module. I tried the other possible solutions first but they did not work. I ordered the part and it arrived in a few days. I had to remove the back panel on the door of the dishwasher with a screwdriver and Torx bit to access the module. Two screws held the module in place. There were numerous wires and plugs to change over. I did those one at a time to make sure I put them in the new module correctly. Once... Read more