Stephanie November 04, 2014 for Model Number LFFH21F7HWA Hi! My freezer seems to be running OK - the food is staying frozen and the display indicates that the temp is 0 F. However, every time I open the door, the control panel beeps and the interior light blinks in sequence with the beeping. It seems like something is wrong, but I can't figure out what is wrong. Any ideas? Thanks!
1 Answer Hello Stephanie. First thing to check is the door switch and wiring. If good, then replace the control board 297235200 on the unit. Read More...
B Maresh October 05, 2014 for Model Number LFFH17F7HWC I have frigidaire lffh17f7hwc freezer and the light inside was blinking on and off and the temp on the control panel was reading 1 degree C. I unplugged the freezer from the wall and waited about 5 minutes, plugged it back in and the compressor came on and the temp went back to showing -17 and freezer seemed to be working normal (Food frozen). Today, the control panel was reading 1 degree C, so I unplugged the freezer for about 5 minutes and plugged it back in and the control panel continues to read 1 degree C and the compressor does not come on. The food is still frozen, but I believe I have a bad control panel. The wall outlet has power as I plugged in a drill to verify,
1 Answer B maresh, If you hold the temp button for 3 seconds it should change to Fahrenheit and if it continues to do the same thing then the control would need to be replaced. Read More...
John September 06, 2014 for Model Number LFFH21F7HWJ I am fixing (or trying to) a Frigidare upright freezer for a friend on limited income so I need help diagnosing a problem. The compressor was running almost all of the time for a few weeks prior to this problem, although it was maintaining proper temperature. One day I noticed that the display temperature was reading 14 degrees and rising.I raised the temp. setting to 20 degrees and the the system shut off. Then I set it back to 5 degrees and it started cooling. The temperature began to go back down, and wehen it go to about 5 degrees the display flashed OF, then FF, and it no longer tried to cool. I have tested the interior fan and it works. I will replace the control board if it is needed, but wold like to be sure that this $100 plus part will fix it for her before spending her money needlessly.
1 Answer John, Based on the description on the problem with the freezer, this issue would be caused by a faulty control board in which you would need to replace the control board 297235200. Read More...
James B August 26, 2014 for Model Number LFFH21F7HW All of a sudden my freezer started with the HI Temp and Door Ajar warning, Temperarture was going up. I read on the internet where this could possible be a defective switch. I bought a switch, but wrong one, for manual model,. I went ahead and replaced the switch with the round one. I closed the circuit on the switch by taping the switch closed. Unit worked great for a couple of days. My wife went to clean the front door and the gasket, while freezer was closed, and immediately the HI Temp and Door Ajar light came on and temperature started rising. Any suggestions.
1 Answer James, The most likely cause for the door alarm and hi temp alarm to go off would be a faulty control board. The control board part number is 297235200. Read More...
Shawn July 31, 2014 for Model Number LFFU14F5HWD I just replaced a brand new electric control for my freezer. Everything is working good except the door ajar light is still showing. I checked the door and it is closed tightly. I used the alarm reset to turn off the door alarm audible but can not turn off the light. Is there anything I can do to fix that problem? Thanks
1 Answer Hello Shawn, You should check the door switch for being properly activated when the door is closed. You should also make sure the switch is operational. As long as you have let the unit get back down to temperature and all tests good, the new board would be at fault. Read More...
Ron July 29, 2014 for Model Number 297366300 Tried to remove the old one and it seems like I am going to break it, Please advise removal of old and the install for the new. Thanks
1 Answer Hello Ron. To remove the Precision Set control assembly: 1. Disconnect power to freezer. 2. Using a small flat bladed screwdriver or equivalent tool carefully pry under the bezel until the retaining latches release from the door assembly. Pull control assembly straight out to avoid damaging the electrical connection wire prongs. To install the Precision Set Control Assembly : 1. Push control in gently with the palm of your hand. You may need to slightly adjust the bezel position up or down to align connector pins. 2. Gently push control flush to the door with palm of hand. Read More...
Jay S June 27, 2014 for Model Number Frigidaire LFFH17F7HWD My door ajar alarm keeps going off. I reset it and it starts again in 5 minutes. The indoor light would also not come on. I have replaced the door switch and the front electronic panel. Now the light comes on but it will not go off and the alarm is beeping again. What else could be causing this?
1 Answer Jay, The most likely cause for the issue will be the electronic control board assembly 297235200. Read More...
Bob June 16, 2014 We can't see the temps on our fridgidaire wall oven. Is there any repair or replacement part available?
1 Answer Hello Bob. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
John May 29, 2014 for Model Number LFFH21F7HWB I have a couple problems and think they might be related to what is broken. I think it's the control board. 1) My upright freezer seems run almost all the time, only shuts down a couple of times a day. I have place two thermometers inside to monitor temp because I think there is an issue with my control board. First I set the temp to 8 degrees, the freezer keeps a temp of 0 degrees most of the time, but some times it can go as high as 10 degrees, what gives? Setting the temp to 0 degrees and I get -5. 2) Sometimes when I open the freezer door, the compressor stops running immediately. To me it's seems the the action of opening the door shook something that was stuck on the control board that is mounted to the door and finally allowed the compressor to shut off, because the inside temp is well below the 8 degrees temp I set. Is something wrong or is this normal?? 3) Also the temp display on the front only seems to display the set temperature and not the temperature inside the freezer, but I remember when I first plugged it in, it use to give the inside temp. Is that right?? I want to know the inside temp to be displayed, not the set temp.
1 Answer John, Based on the information provided it sounds like the issue would be a faulty control board 297235200. Keep in mind though that the temperature fluctuation is +/- 5 degrees. Read More...
Mike May 26, 2014 for Model Number Frigidaire LFFH21F7HWJ freezer I would like to run this unit at refrigerator temps if I can, do you have a replacement control unit that can do this?
1 Answer Mike, This unit does not have any controls that would be available for it that would allow the unit to work as a refrigerator. Read More...