Troy January 04, 2026 for Model Number Ge Profile Artica I bought this WR17X2202 filter head will it fit my fridge
1 Answer Troy, To determine if this filter head will work, we will need to have the refrigerator model number. Please resubmit your question with the model. Read More...
Susie October 30, 2023 for Model Number PSHS6RGXCDSS Water is leaking and sometimes misting from the connection between the water tube come from filter and where it goes into the water inlet valve? Do I need to replace with the entire part or it there a way to fix the connection or only replace the tubing?
1 Answer Susie, Based on the information provided I would recommend replacing the filter housing and the filter. Read More...
Eric June 27, 2021 for Model Number WR17X22072 I have a bad tube fitting going into the solenoid valve. Do I have to replace the entire filter housing with attached tubes or can I change just the tube?
1 Answer Eric, if the model number of your appliance could be provided in a new question, this will allow the most accurate information to be presented. Read More...
Rick Rohas May 28, 2021 for Model Number GE Refrigerator PSHS6RGXCDSS When the ice maker calls for water, a loud vibration or rattle lasts for the length of time it takes to fill the ice maker tray. I cannot tell what component is causing that. Several years ago I changed the water dispenser assembly that holds the filter, as the refrigerator made a similar rattling noise when we tried to get water dispensed from the door. Please let me know what I need to replace so I can order the part. Thank you.
1 Answer Rick, It would be recommended to check to make sure that the water tubing is secured to the back of the refrigerator as this could be the issue. There could also be an issue with the water valve causing the water line to jump or chatter. Read More...
Michael August 25, 2020 for Model Number PSCS3RGXAFSS Will this manifold work for my refrigerator? Thanks!
Coros September 24, 2019 for Model Number PSS26NSWCSS Paco asked a similar question, but it wasn't resolved. I purchased this part from another site and the fittings were different sizes than the original. I would like to order this one from you as it says it fits my model refrigerator, but can you confirm that? Have you had issues where the new fittings were smaller than the original?
1 Answer Coros, the manufacturer does specifically list the filter housing WR17X22072 for your model. In regards to improperly sized fittings, the manufacturer has not notated any information on this and therefore it should fit properly. Read More...
Paco July 27, 2019 for Model Number PSCS3RGXCFSS I purchased a replacement filter housing assembly (genuine GE part WR17X12203) but the one of the hose fittings is smaller than the original part, making it impossible to install. Did I order the wrong part?
1 Answer Paco, this is the correct filter housing assembly for your model. There should be one end that has a 3/8" threaded male connector for the incoming water line from the house and an end with a 3/8" nut while the tubing has a beveled end. Both sides are designed for a standard inlet thread and the beveled end should fit onto the threaded inlet of the valve. Read More...
Diana Parra February 14, 2019 for Model Number PSF26NGWC BB I need to change my GE water filter housing and tube. Would you please send me one or two videos of how I should do the change. It is the first time I do it. Thanks,
1 Answer Diana, Here is a video to show how to change the water filter housing. https://www.youtube.com/watch?v=Tvb8NweXBb4 Read More...
Tracey November 11, 2018 for Model Number K5SRB25FKSS00 How do you either flush the water line or fix the taste of water. We put a new filter and took out 4 gallons of water through the water line. It is not tasting good?
1 Answer Tracey, check the supply line that feeds water to the refrigerator, if it is not rated for a refrigerator, it may give off a plastic taste. Also, if there is a food taste, there may be something in the cabnet that is being circulated and absorbed into the ice. Normally, the tubing that is built into the refrigerator is not something that puts off any kind of odor. Read More...
Nick April 19, 2018 for Model Number PSS26MSWASS I installed a new water filter and now the flow has almost stopped at the dispenser. What part is most likely needed? It seems like the filter is filling up but when you dispense, it has a spurt of water then a slow stream. Thanks!
1 Answer Hello Nick. It sounds like the water filter head WR17X22072 is bad and will need to be replaced on the unit. Thank you. Read More...