Dave R January 17, 2018 for Model Number Hsm25gftc Water shoots almost straight out when dispenser is pressed and sometimes will not cut off unless dispenser paddle is manually pulled forward. Also, Ice sometimes will build up in door disp. And then a bunch will come out at once.
1 Answer Dave, If the water is spraying out without going into the cup then this will most likely be a issue with the water tube in the door. As for the dispenser paddle being pulled out then this will be a issue with the dispenser housing that may be the issue. WR17X11170. Read More...
Robert A July 22, 2017 for Model Number RCA MSX25DRZBWW I Think, The complete Model No. is not shown All my previous refrigerators with water & ice dispensers in the door had a water filter usually mounted in the top of the refrigerator door. This RCA unit doesn't seem to have any filter at all. Do I have to install a replaceable water filter in the supply line myself?
1 Answer Robert, Yes this refrigerator would need to have a in line water filter installed between the refrigerator and the supply. Read More...
Frank August 17, 2016 for Model Number HSS25GFPDWW Do they make a heater kit for this hotpoint refrigerator because of water line freeze up of water through the door.
Kent S June 04, 2016 for Model Number PSI23NGMC WW The condenser in the back is running really hot, and the left side of the fridge when looking from the front is also hot as is the center divider that you can feel when the doors are open. The fridge was running almost constantly for a while. Now I've cleaned the round thing that the fan is connected to and it's much better but it still gets a little hot on the left side of the fridge in two places, one high one low. My question is if this is normal to get warm at these places when the fridge runs? And does the condenser often get pretty hot during the running time. Like I said before I cleaned that round part it was hot and running almost constantly. Thanks a lot for any help, I'm trying my best. Kent
1 Answer Kent, With the condenser and the sides of the refrigerator and the center divider running hot you will want to check to make sure that the condenser fan motor is running. If the fan is not running it can cause the compressor to overheat and cause the walls and divider to get hot. This can also cause the unit compressor to overheat and shut down. If this checks ok then it sounds like you may have a sealed system issue in which you will need to have a service technician to check the unit. Read More...
Bob December 18, 2015 for Model Number gss22jeteww What is recommended temperature for freezer my water dispenser keeps freezing
1 Answer Hello Bob. The recommended is 0°. You will need to install a heater kit WR49X10173 in your model. Read More...
Patrick F. November 07, 2014 for Model Number GSS25QGPDCC I understand that there is a heater for the water tube in the door to keep it from freezing. I couldn't find it in you door parts. Can you give me the part number, price and a diagram for installation?
1 Answer Hello Patrick, There is a heater made for the GE refrigerator, WR49X10173, but it will only fit metal liner SxS production built January 2003 through January 2007 (serial numbers AF through AM): Models BSS, DSS, ESH, GSH, GSS, GST, HSS, and SSS. The current pricing is listed on the webpage the part is illustrated on and it comes with installation instructions. Read More...
John M June 11, 2012 for Model Number gsh25jsxlss The waterline in the frezzer door keeps freezing up. I took this off this page but cant find the kit to keep this from freezing up the manufacturer actually has kits to help with the water issue. We will need your model number to locate the correct kit for you unit. Here is a link to our repair forum regarding this issue: http://forum.appliancepartspros.com/refrigerator-freezer-repair/6787-ge-fridge-ice-maker-works-water-dispenser-does-not.html Read more: http://www.appliancepartspros.com/Appliance-Parts/ge-slv-watr-lin-item-number-ap2060593.aspx#ixzz1xVKXvjo5 http://www.appliancepartspros.com my mod.# gsh25jsxlss now i sent you the model number can you send me the kit part number ???????
Scott May 07, 2012 for Model Number GSS22JFPAWW How do you replace the water dispenser line inside the freezer door? It broke off at the base of the door right at the hinge. Thanks
1 Answer Hello Scott. The only way to replace the water line in the door is to order the door assembly WR78X11646. Read More...
Jorge May 06, 2012 for Model Number GSS25UFPACC My water line only works if I leave the door open for a few hours leading me to believe that the line is freezing, what could be causing this and how do i fix it? I dont want to be leaving the door open all the time. This kind of defeats the purpose of having a freezer!
1 Answer Hello Jorge, Sounds like you need to adjust your temperatures. The controls only give a general idea of where to set them. I recommend setting the temperatures using a freezer thermometer. Set it in the freezer compartment and don't check on it until first thing in the morning after it's been closed all night. You should have the thermometer setting in a position where you can read it without touching it. If the freezer drops below 0°F, set the control to a warmer setting. Be aware that refrigeration is a slow process. If you make more than one setting adjustment within a 24 period, you are essentially lost and will not be able to predict what average temperature the unit will run at. It takes about three to zero the temperature in and then you can move the thermometer to the fresh food side. The temperature in the fresh food side should be adjusted to 35°F to 38°F. This takes about three days also to zero in. Then move the thermometer back to the freezer side and make sure the next morning that the fresh food adjustments have not changed the freezer temperatures to below zero. There is also the possibility that there is a void in the insulation in the freezer door. Let's hope this isn't the case as it would require the replacement of the door. This is rather costly so adjust your temperatures first. Let us know if we can assist further. Read More...
Randy H. April 13, 2012 for Model Number GSL25JFPHBS I cant get water out of the dispenser if I un hook the line at the bottom of the freezer door union I get water I blew air with a air compressor and I cant get air to come out of the dispenser either I tried to fish a wire through which it will not go what next please
1 Answer Hello Randy. The water line in the door is frozen and will need to be thawed out. If you unplug the unit and leave the freezer door open for about 6 to 8 hours, it will thaw out. Hope this helps. Read More...