Carlton December 30, 2015 for Model Number 110.44832.200 Need a drain pump motor for a Kenmore Elite HE3, and your site comes up with this part. Will it cross reference to a Haskol 461970201671 motor for this washer? I can't see electrical connection in pic, but otherwise they look the same as far as mounting flange, tabs, etc. Thank you.
Mercedes December 12, 2015 for Model Number LGTROMM I have an LG TROMM that is 6 years old, but cannot find the model number. One day, it started making a very strange noise at the end of cycle and smoke formed inside washer. A technician came to repair and recommended to change motor if it hapenned again. Is the drain motor what we need to change? Thank you
1 Answer Mercedes, With the issue happening at the end of the cycle it would most likely be the main motor that the tech was referring to. If the noise is a roaring type noise then it may be bearings that are going bad on the drum. Read More...
1 Answer Hello Steve. Test for power to the control board. If there is power there and the unit does not come on, you will need to replace the control board on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Beth November 05, 2015 for Model Number Model WM2301H I have LG Washer - after washing clothes the washer put dark grease on my clothes. Some black thinks in my washer. What should I do?
1 Answer Beth, If you are overloading the unit it can cause pinching of the clothes which could cause black markings on the clothing. Try to run a smaller load and see if it is still occurring. If the unit is still doing this then you will want to check the tub seal on the inside of the unit as it may be causing an issue. Also try to run the unit through a clean cycle and see if this does not help. Read More...
Rhonda October 28, 2015 for Model Number WM2487HRMA My washer was making a horrible noise when it would drain and now is giving me error code OE, what parts will I need to order in addition to this one?
1 Answer Hello Rhonda. Based on the information you provided, it sounds like the drain pump is bad and will need to be replaced on the unit. OE is a drain error. Read More...
Jim October 14, 2015 for Model Number WM2496H*M As you can see, the appliance model number on my waser has an asterix between the letters H and M. I cannot find this model listed on your site. I bought this washer in 2006 and I need a drain pump. Could you tell me what the part number is for this model.
Briand October 13, 2015 for Model Number DPO 40-038 Have an 7 yo LG washer that had the drain pump get clogged up from a bobbie pin. Pump is still working, but the seal got damaged and I need a replacement O-ring. no idea on size, where can I get just a replacement O-ring. I can't seem to find the right size. I'm not going to replace the whole pump for a 3.00 part. Please help?
1 Answer Hello Briand. The only way the manufacturer offers the o ring is with an new pump assembly. Read More...
John September 23, 2015 for Model Number wm2496hsm Just replaced water inlet valve, not the issue. Turn unit on, select cycle, unit door locks, drum turns during load sensor, then I get a humming noise from under the drum towards the back. No water gets sent into drum, just a humming noise. Any ideas of what it could be?
1 Answer Hello John. You need to locate the part that is making the humming noise. If it is the valve, you will need to check the water supply coming to the water valve. It could be the door lock also. Read More...
Natalie F. September 03, 2015 for Model Number WM2233HW The drain pump motor went bad on my washer. I believe the part # is DPO 40-038 (Hanning Elektro-Werke) It looks similar to part AP5328388. Will this part work in model # WM2233HW ?
1 Answer Hello Natalie. No, you will need to order 4681EA2001T for the drain pump needed. Read More...