Mike V January 03, 2023 for Model Number Whirlpool Model WRB322DMBM00 I’ve tested the the system with jumper from T to H and it cycles through but water does not fill the tray upon completion. I’ve tested the water with jumper from V to L and it will fill the tray manually so I know it’s not plugged. Freezer is at 10 degrees. But it still won’t run on its own to make ice. Got any ideas? Thanks!
1 Answer Mike V, 1. The proper cycle temp is between 0°f to 8°f for the thermostat to close and initiate a cycle, you may have a cooling issue. 2. It should however fill on the test cycle (T-H) so you may need to replace the ice maker module or the ice maker. Read More...
Alan Y December 04, 2022 for Model Number LFXS30796D/01 refrigerator started melting ice from icemaker and found out the refrigerator stopped cooling. replaced compressor overload protector as you suggested and it still does not work. fan runs but no cooling.
1 Answer Alan Y, You state that the fan runs, the next question would be, do the condenser fan, the evaporator fan, and the compressor run? If these are all running then you will likely have a sealed system issue and would need a certified tech to complete these repairs. Read More...
Barbara December 03, 2022 for Model Number Lg lmxs30776s/03 My icemaker will make ice and dispense only when pressing the icemaker reset button at the bottom of the icemaker. It will not refill with water automatically. No error codes. Everything appears to be working properly accept for the fact that it will not refill unless I press the reset button. Thank you.
1 Answer Barbara, Thanks for the question!!! Replacing the icemaker AEQ73110210 should solve your issues. Read More...
Randy August 20, 2022 for Model Number Samsung refer..RSG307AARS Every month or so my icemaker jams up. It won't dispense ice although it is full. So I have to break it down and restart with an empty bucket...a Hard job. Any suggestions?
1 Answer This often occurs from not being used often enough. Draw a glass of ice every day even if you won't use the ice. Doing so will keep the ice in the bin fresh and moving. Read More...
Zain May 14, 2022 for Model Number Samsung Refrigerator Model RF28HMEDBSR The refrigerator and ice bucket is working fine. However, the dispensed ice has small shredded pieces of Styrofoam mixed in along with ice cubes. What could be the problem? Is there something can be done? Any suggestions/help would be appreciated. Thx
1 Answer Sain, the styrofoam would likely be from the insulation located just behind the ice maker. It would be recommended that the ice maker section is inspected for any ice accumulation on the bottom and inside of the insulated vent that could be occurring from an air leak. If there is ice built up, it would need to be cleared using a hair dryer set at room temperature air, followed by sealing the side seams of the ice maker section using a food grade sealant DA81-05595A and installing a y-clip assembly DA82-02367A. Read More...
Peter August 14, 2021 for Model Number WRX735SDBE01 I have a problem with the ice maker leaking into the ice bin causing the ice in the bin to freeze in a clump. this is what I have found out so far. after hearing the ice drop I took out the ice bin and held the lite switch in to trick the fridge that doors were closed. After a minute, the fill solenoid opened for a short time to fill the tray. a minute after the solenoid closed, water started to very slowly drip from the front of the ice maker. it stopped after a minute. if the ice bin was in place this leak would freeze the ice in the bin together making clumps. What do you think the solution is?
1 Answer Peter, based on the information provided, the ice maker WPW10300024 would need to be replaced. Read More...
1 Answer Larry, The most likely cause for no water being in the ice tray will be either a clogged fill tube or the water valve being defective. Read More...
1 Answer Ira, Replaced the evaporator cover assembly for the refrigerator section, the fan comes in the assembly...our part # DA97-12609C Read More...
Sam July 31, 2019 for Model Number BX21TL My fridge and freezer are not cooling as much as they should. The fridge is at about 42 deg, and freezer at 20-22 deg, with both set near max coldness. Several days after it started not cooling as well, I found oily brown liquid, maybe an ounce, on the floor at the left front corner, standing in front and looking at the unit. It is still cooling some but not like it did. The condenser fan seems to work properly. Is this a refrigerant leak that stopped??
1 Answer Sam, the oily brown liquid mentioned could be oil from the sealed system mixing with water from the drip pan or it could be discolored water that is leaking from the drip pan. The evaporator will need to be inspected for a frost pattern. If there is not a frost pattern on the evaporator, and the condenser coils are clean, then it is likely that there is a freon leak in the sealed system. With any freon issue, a licensed technician would need to be contacted for repairs. If there is a frost pattern that is partially restricting airflow at the evaporator, it is possible that there is a partial defrost occurring and causing this issue. Read More...
Connor December 08, 2018 for Model Number RS2577SL My ice maker is not working and there is frozen water all over the inside of the freezer the ice cube tray is a solid block of ice. Thanks,
1 Answer Connor, This issue sounds like it would be caused by a faulty water valve that is not shutting off if the ice maker is overflowing water and not making ice. Read More...