Jason April 30, 2018 for Model Number DW80F600UTS/AA-0000 Could a hole in the filter (DD63-00104A) cause an over water level error? What might need to be fixed to resolve?
1 Answer Hello Jason. No, not likely. However, it does need to be replaced if it has a hole in it. As for the issue at hand, it sounds like the case break DD82-01373A is bad and will need to be replaced on the unit. Thank you. Read More...
Jesse January 22, 2018 for Model Number Samsung DW80J3020 Was trying to remove the mesh filter and screwdriver slipped and poked hole in it. Is it ok to run dishwasher with hole in filter?
1 Answer Hello Jesse. No, you will need to replace the filter so nothing large damages the pump. Thanks. Read More...
Teresa M. June 12, 2017 for Model Number DMT400RHS/XAA When I start dishwasher up it will run for maybe a minute and stop. Two cycle lights will light, the heavy and auto smart. What part is needed? Thanks
1 Answer Hello Teresa, This is the fault code for an over-level water error. This can be caused by the flow meter DD94-01006A, the main control board DE92-02256C, or the water valve DD62-00084A. Read More...
David February 29, 2016 for Model Number DW80F600UTW/AA-0000 I have a hole in my screen/filter cover which covers to pump at the base of the pump. I have removed all the screws and cannot seem to remove the screen. Thanks
1 Answer Hello David. Make sure all of the screws are removed and the center post. If so, the screen just lifts out of the sump housing. Read More...