Customer Questions and Answers for Dryer Lint Screen Grille by Whirlpool

Donnamaria, We're sending you the information you requested. Once you review the information, you should do fine. Thanks

Hello Anna! There are two screws for the side of the outlet screen grille, part number WP3387230, and one bottom, part number WP488729. Thanks!

Hello Anna, It doesn't matter which wire goes where in this case. The two sensors just have to be hooked up so when a wet cloth passes over it, it can read the resistance and operate properly.

Anna, Fortunately, it doesn't matter. The wires you're describing are for the "sensor" bar, so as long as both wires are attached to the bar terminals, you'll be fine. Thanks and Good Luck

Hello Dan. No, you will need to order WE18X10010 according to the model number you provided. Hope this helps.

Hello Karie! The outlet screen is part number W11086603. This part is attached using screws part number WP3387230 and WP488729. The sensor on the outlet screen is part number WP3387223. Please note, you should be able to use the existing screws and sensor from the previous outlet screen if the outlet screen is the only defective part on your appliance. Thanks!

Hello Viv! There are two different screws used on the outlet screen grille. There is WP3387230 and WP488729. We have pictures listed of both items. Hope this helps!

Hello Viv. WP3387230 is the screw for the lint filter grill. Hope this helps.