1 Answer Christine, With the unit not draining, check to see if there is 120 vac getting to the drain pump. If there is 120 vac to the drain pump then check to make sure that there are no clogs in the hoses or the drain pump. If not then replace the drain pump. If there is no power then replace the control board. Read More...
Stephanie P October 28, 2021 for Model Number MVWC200BW0 Hi! I have this model and it was banging and shaking horribly and then it wouldn’t go back into spin after I tried it again. What could it be and what are the associated part numbers? I am trying to fix this for my handicapped mother as she cannot afford a new one. Thanks in advance! ??
1 Answer Stephanie P, Based on the information provided the suspension kit part number is W10780045 Read More...
Ann June 25, 2021 for Model Number WTW5000DW0 you show the suspension rods in diagram. but no listing for the part number. I have a whirlpool top load washer M# wtw5000dw0 would like to know whats part number for a suspension rod kit
1 Answer Ann, Thanks for the question!!! The correct kit for your model number is [AP262443]. Read More...
Ken June 18, 2020 for Model Number 110.20222510 My Kenmore washer is banging and banging on spin cycle how do I know if i need suspension Ross or just suspension bearning, model number 110.20222510
1 Answer Ken, Per the manufacturer, the only test for the shock absorbers is to push down on the tub and let off quickly. If the tub bounces up and down the shocks need to be replaced.Make sure all 4 feet are on the ground and try rocking the machine from opposite corners. Read More...
Tommy July 29, 2019 for Model Number Caw9244xq I have a Crosley extra large capacity washer 2013ish. I need a complete repair on the suspension rods but i dont know which one to get. Serial number is C31330573 and model number is CAW9244XQ
David October 04, 2018 Will park #AP5306956 fit model Model MVWB835DW2 serial number c73172557. Your cross check says ok till I enter the 2 on the end.
Villager August 17, 2018 for Model Number ATW4675YQ1 experiencing excessive unbalanced wobble even after re balancing the load. possible causes?
1 Answer Villager, you may need to replace the suspension rods. Over a period of time the springs get weak and will allow excessive movement of the tub. part number is W10780048 Read More...
Ron February 12, 2018 for Model Number MVWC425BW0 What is part number and cost for complete suspension kit, including suspension, suspension rod kit, and any springs necessary?
1 Answer Hello Ron. You will need to order W10780044 for the suspension kit needed for the unit. Thank you. Read More...
Frank Masters November 30, 2017 for Model Number ATW4675YQ1 what is the part number and price for a suspension rod kit for this washer and do you have it in stock?
1 Answer Frank, The suspension rod kit for the model number you supplied is W10780048 / W10780048 Suspension Rod Kit. The part is in stock, and available at this time. The cost of the part is $44.82, plus shipping and state tax if applicable(CA.,TN., PA.) Thanks, Read More...
1 Answer Hello BB. There is 2 screws in the hinges on the back. Only remove the top screw on each side. Leave the lower one. Then pull the top forward and lift to raise the top of the unit. Once inside, you will lift the tub assembly and remove the suspension from the bottom, then the top and change the parts 1 at a time. Do not try to replace all 4 at the same time. Thanks. Read More...