Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This wax motor is the actuator for the dishwasher's rinse aid dispenser, releasing rinse agent at the correct time in the cycle. Replacing a weak or failed unit restores consistent rinse aid dispensing and helps minimize spotting.
I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more
This hose clamp secures a hose connection to prevent leaks and keep your appliance running smoothly. It provides a tight, reliable hold on the hose fitting so water or air stays contained during operation.
Took off cover, installed new parts. Read more
This replacement door handle restores a secure grip and normal door operation on compatible Whirlpool appliances. It provides a like-for-like fit and finish to replace a damaged, loose, or worn handle so doors open and close reliably. What it does:
I installed the door latch assembly and handle. It worked fine after that. Read more
Note: Check Serial Number for correct part
The grommet was old and very caked with old dishwasher scum. So water was leaking through where the soap door latch goes into the door. I replaced the rubber grommet (and the plastic latch that came with the kit, even though the old one was probably fine). Fit perfectly and looked just like the old one. Works like a champ, no leaking! Read more
This float palnut is a push-on retainer that secures the dishwasher's water-level float to its stem. Keeping the float anchored helps the overfill protection work properly, supporting correct fill levels and helping prevent leaks from overfilling. What it does:
I first installed the inlet pump with no results. I then ordered a Control Switch and Float and Nut. This fixed the problem. Everything comes out so clean. I also replaced the filter which allowed me to clean debris around old filter. It is also easier to replace all these parts with the dishwasher pulled out and tilted on its side. I had to pull mine out to unplug power to the dishwasher. Read more
Attaches to the inner tub for the upper rack
Replaced left hand rack adjuster. Read more
Pan-head screw used to secure panels, brackets and trim on Whirlpool appliances. Replacing a damaged or missing screw restores proper fastening to reduce vibration and keep assemblies aligned during operation. What it does:
Looked up model on your website. You had all the parts I needed, numbered and visually shown. Perfect! Read more
This is the longer of the two dispenser lid hinge pins. For the shorter lid hinge pin order WPY912679.
The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more
Dishwasher lower wash arm and spray tower support.
Ordered parts from appliance pro and installed was a easy repair saved service call no tolls was neede Read more
This is the shorter of the two dispenser lid hinge pins. For the longer lid hinge pin order WP6-912678.
Long tub insulation that fits the appliance's inner tub, reducing operating noise and helping stabilize temperature around the tub for quieter, more consistent performance. Replaces worn or damaged insulation to address rattles and drafts. What it does:
Replaced the insjulation blanket Read more
This power cord strain relief secures the cord where it passes through the appliance cabinet, protecting the jacket and preventing pull on internal connections. Replacing a cracked or missing connector restores a safe, stable cord entry. What it does:
To order indicator lens use WP22001948.
This impeller assembly replaces a worn or damaged wash-pump impeller to help restore water circulation and spray pressure for better cleaning. Commonly used in compatible Whirlpool wash pumps to address weak wash performance. What it does:
The initial problem was just a simple blockage on the filter screen...until I dropped a screw. So, I had to take the rest of the insides apart to retrieve it. The original impeller would not come off easily, so I tried to pry it off. Naturally, that caused the threaded portion to break. The new impeller went on much more easily than the old one came off, and the dishwasher is back in action. Simple repair; there's really not much to the inside of this thing. Read more
Dishwasher rack rear bowl tine. For the front tine order 12002218. For the tine clip order WPY912709.
I ordered new replacement parts. Read more
Replaced it with a new one from appliancepartspros. Couldn’t be happier, easy install, works great Read more