Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replacement actuator paddle for refrigerator ice and water dispensers. Installs on the freezer door. Needed when the original is cracked, broken, or missing.
Removed complete housing, including the actuator to dispense ice; plastic cemented, with reinforcing strips of cloth to reinforce repair on left hand side of assembly. Then installed new actuator part from Appliance Parts, plugged in wires, then had to plastic cement the pack on back of the new actuator back on, as it had come loose. Reassembled all, and finally managed to get the water discharge tube back through the hole, than replaced the flat strip connector & replaced all screws. Works... Read more
Plastic bearing that sits in the upper hinge, allowing the refrigerator door to swing smoothly and quietly. Replace if cracked, worn, or broken.
Went to site at 4pm central, found part, watched repair video, ordered part, part arrived NEXT MORNING, replaced part, door works perfectly. Total time for web research, ordering AND repair: Less than 30 minutes. Total cost with delivery: $21.66. Door works just like new. It doesn't get any better than this folks. Read more
Torsion spring that returns the dispenser ice chute door to closed position. Replace if broken, weak, or missing to restore proper door closure.
I wasn't sure if it was the door being warped, the spring return being worn, or the rotary damper failing, so I ordered all to update the door mechanism. I also ordered a new micro switch since one of the switches had started to require more and more pressure to actuate. Figured I'd fix it at the same time. Repair was very straightforward and the videos available on this and other repair sites were very helpful. I found a video that showed replacing the door mechanism on a nearly identical... Read more
Freezer not cooling below 32°F or water leaking under freezer? The drier filter removes moisture from the refrigerant system. Soldering required.
Had a friend who is an appliance repair tech. Replace the evaporator, the heater coil, and the filter/drier. Parts were soldered together and the compressor was put under vacuum. Then, charged with 5 oz. of refrigerant. The freezer works great now! Read more
Connects your refrigerator to the wall outlet to supply electricity. Replace if the original cord is frayed, damaged, or has exposed wires from wear or moving.
Evaporater fan would not run. Unplug the fridge and plug it back in and the fan would run for a while. Installed the UI-KIT SXS and the problem was fixed. The kit saved $ over ordering each part separate. I didn't know which part was bad. Saved more than half the cost of Main Switch Board when ordering the kit. Fast shipping! Shipped 2hrs after I ordered! Read more
Seals the fresh food compartment door to prevent air leaks and maintain temperature. Replace if torn, loose, or causing condensation. Confirm fit.
Replace the gasket, very simple Read more
Secures the evaporator fan motor to its bracket for proper airflow. Replace if broken or missing to eliminate vibration, noise, or cooling issues.
Walk into the kitchen on 21 Sep. Eight year old Frigidaire refrigerator appears to be short cycling, controls are nonfunctional. Unplug it for a few minutes, plug it back in, appears to return to normal function. Return to kitchen half hour 45 minutes later it's short cycling again. Panel has codes on it (S or 5 E CE, later that changes to S or 5 Y CE). Research of codes says replace main board and control board. Not sure where this main board is. 22 Sep call appliance repair. "Soonest... Read more
Ice not dispensing or auger won't turn? The drive bar transfers motor rotation to crush and dispense ice. Moderate DIY repair with video guide.
My problem started with a rusting condition in the ice bin that spiraled out of hand. I took apart the ice bin and all the hardware thinking I could clean it with the suggested baking powder. Plastic parts cleaned up like new, metal parts were pitted. I wire brushed and sanded the parts put it all back together and gave it a try. All appeared fine then two days later the ice dispenser stopped. I watched a couple of videos and most pointed to the ice auger motor. One video specifically said you... Read more
Covers the bottom front of your refrigerator. Replace if cracked, broken, or missing. Clips into place at the base to restore appearance.
Snapped it on. Read more
Refrigerator light won't turn on or flickers? A faulty light socket is often the cause. This snap-in replacement restores interior lighting in 10 minutes.
I found your website, watched the video on how to fix it and ordered the part. Really a simple fix. Did I mention the super Fast shipping. Amazing! Thanks Read more
Fastens the auger shaft in your refrigerator's ice maker assembly. Replace if cracked, broken, or missing to secure the auger and prevent rubbing.
Replaced "Ice Crusher Housing" and "Fixed Blades Spacer, both of which had broke. Read more
Fix refrigerator lights that won't turn on when door opens. This door light switch is a simple snap-in replacement. Easy 10-minute DIY repair.
Switch replacement was easy: -unplug fridge -using medium flathead, pry out old switch, starting from back, be gentle it's all plastic -when switch pops out, grab the wires and don't let them fall back into hold -there should be three wires -connect to new switch in same pattern -push new switch back in, being careful to orient it correctly while replacing the freezer switch, i noticed that one of the wires had loosened up and detacted from the old switch anyway, which was probably the actual... Read more
Ice won't dispense or gets jammed? This ice bucket assembly stores and feeds ice to your dispenser. Restores smooth dispensing in about 20 minutes.
I ordered part from appliance parts and it was perfect fit. Read more
Nylon washer for the evaporator fan motor shaft in refrigerators. Replace if worn, cracked, or missing to ensure proper fan alignment and operation.
Plastic drip tray installs under the refrigerator water/ice dispenser to catch spills and drips. Replace if cracked, warped, discolored, or missing.
I removed the old one and put the new one in. It took about 1 minute. That is because I am counting the time it took from opening the package, removing the old dip tray and replace it with the new one Read more
Insulated cardboard cover assembly that installs on the rear bottom of your refrigerator. Replaces a cracked, torn, or missing original cover.
Ordered all the parts I needed to finish off a Craigslist purchase that had some cosmetic and function items missing. Thanks for all the parts at great prices! Read more