Central Pack Small Engine Carburetor Gasket Parts

New seals installed. Read more

Removed old seal and replaced with with new seal. It took approximately 5 minutes, the new seal just snaps in on this model of refrigerator. Also, the new seal came nicely boxed to prevent wrinkles. Read more

Replaced it. Read more

Ordered the part via the model number. Removed the old gasket (just pulls out of the indentations and cleaned the channel for the gasket. Pushed into the channel and no more frost forming in the freezer. Read more

Remove old gasket clean the area and put new gasket on Read more

Based on my model # and serial # the Appliance Parts Pros were able to quickly find and ship the gaskets I needed. The instructional videos showed me how to remove the old and replace with the new. I was able to easily do it myself. Read more

Put a new one on. Read more

Checked out You tube video. Easy tune up. One gasket was damaged and I did not notice that the brush holders has no brushes. I believe a quick call to Appliance parts pros will fix this, besides I need a few more parts. I expect to get another 20+ years from this KitchenAide mixer, once repairs are competed. Watch out for the single lock washer located on the rear upper housing screw, you don't want to lose this! Read more

Just like the one's I have worked on for 30 years for Whirlpool. Read more

The symptom was suds and water on the floor at the left front of the dishwasher within the first five minutes of operation. Examination of the seal inside the door showed it was warped and pushed up into the door out of place. Once disassembled we found a tear in the seal, severe warping, and the material was sticky and slimy rather than flexible. I found a video of the disassembly that was very helpful. It is necessary to pull the dishwasher out of the cabinet but my installation had no top... Read more

The freezer door on my 12-yr old GE side-by-side refrigerator/freezer would not stay completely shut resulting in temperature variations and ice buildup from outside humidity seeping into the freezer compartment. These problems were exacerbated by the fact that this appliance is located in my garage in the heat / humidity of the Atlanta, GA area. I applied a thin layer of petroleum jelly to the gasket which improved the seal but did not completely solve the problem. I discovered that... Read more

Replaced both the door gasket * defrost timer and everything works great. Read more

Ordered New Gasket and installed in about 3-4 Minutes. Only need small pliers to remove some of old clips from holes. New Gasket clipped in easily by hand. Read more

I searched online for replacement parts and Appliance Parts Pros had the part in stock. Before I ordered the part, I watched the video to see if I could handle the repair. I ordered the part and soaked the gaskets with warm water in the tub. The old gaskets had a much simpler setup, so no cutting was involved. I simply pulled the old gasket out of the track without issues, and installed the new one with finger pressure. Per the video, I took both doors off. However, due to the design, I could... Read more

• Leaking

After discovering your web site and reading of others issues I ordered a door seal (my old one was a little short on the right side) a detergent door grommet, and the 2 water deflectors ( I decided to cover all the bases while I was at it. Very simple job with the information provided on your web site. I certainly have the confidence to tackle other appliance repair now. Read more

Initially did a uTube search for specific instructions on dismantling this machine for this repair. I had successfully replaced a door/tub gasket on a Whirlpool front load machine previously. Did not find specific uTube instructions for this Kenmore. So began removing parts using past learned info on what needed to be removed first, second, and last. Removed the top, detergent dispenser screws/control panel, then the front (with a couple hidden screws around drain pump filter) and the front... Read more