Customer Questions and Answers for Switch(Fan) by Ge

Sagun, Here is the instructions for removing the control panel to replace the fan switch. 1. Disconnect all wire connectors to the motor, light and control panel. 2. Pull to remove knob on the control panel. A 3. Cover the Lexan® control panel surface with tape to prevent scratching. 4. Locate the long push rods holding the control panel in place. Remove the screws holding the rods. Slide rods out of the slots. Set screws and rods aside. B 5. Carefully, rotate and slide the control panel through the opening on the right side. C 6. Check and/or change all components creating reported problems. TO REINSTALL THE CONTROL PANEL: • Rotate and slide control panel into the opening at the right side. • Hold control panel in place while inserting the long push rods through the slots in the light panel support. • Loosely reinstall screws through the rod, panel and into the cage nut. • Use fingers to hold the panel in correct position while tightening screws. • Reinstall the light cover with original screws. • Restore power and test the controls and lights.