Parts for Whirlpool WFG525S0JB5: Chassis Parts

If your burner flame is uneven or yellow, or the burner sits loose, the burner box may need replacement. Restores proper gas flow and alignment.

Replacement side panel for your dishwasher. Covers the exterior side of the unit. Order a new panel if yours is dented, scratched, or damaged.

Replacement side panel that restores your range's exterior finish. Covers dents, scratches, or damaged cabinet trim. Easy-to-install cosmetic part.

Range door insulation clip secures insulation retainer between inner glass panels. Replace if loose, broken, or missing to maintain door seal integrity.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Replacement mounting screw for ranges. Secures panels, trim pieces, control boards, and brackets. Order when original screws are missing, stripped, or damaged.

Front leveling foot adjusts range height for stability. Replaces cracked, broken, or missing feet. Ensures proper leveling to reduce vibration.

Adjustable leveling leg installs on the front or rear corners of your range. Replace if broken, cracked, or worn to stabilize and level your appliance.

Replaces the oven floor panel that sits above the bake element. Needed when warped, cracked, or damaged from spills or foil contact. Restores smooth surface.

Oven not heating to correct temperature or overheating? The temperature sensor monitors and maintains accurate oven temps. DIY repair in 30 minutes.

Burner baffle installs under your gas range cooktop burner to shield components and direct heat. Replace if cracked, warped, or missing from use.

Protect internal components from excessive heat with this gas range heat shield. Replace if cracked, warped, or missing to maintain safe operation.

Lower heat shield for gas ranges. Protects internal components from excessive heat. Replace if cracked, warped, or damaged to maintain proper insulation.

Structural support base for range drawer rail assembly. Replacement needed when original is cracked, broken, or warped causing misalignment or instability.

Structural support base for range drawer rail assembly. Replacement needed when original is cracked, broken, or warped causing misalignment or instability.

Replace a broken or missing door switch actuator rod on your range. This small rod engages the door switch to detect open/closed positions and control the interior light.

Mounting screw secures panels, control boards, and burners inside your range. Replace if lost, stripped, or corroded to keep components stable.

Replacement screw for securing range components like panels, brackets, and burners. Needed when original screws are stripped, missing, or damaged.

Mounts to the range frame to anchor the door hinge arm. Replace if cracked, bent, or worn to restore proper door alignment and smooth operation.

Replace your burned-out range light bulb to restore interior illumination. Swap in when bulb fails to see contents clearly. Verify fit by model number.

Complete front door assembly for electric and gas ranges. Replaces cracked, dented, or misaligned doors that no longer close or secure properly.

Replacement latch rod for range oven doors. Connects the door latch mechanism to enable proper door closing. Order a new rod if yours is broken or missing.

Fix F5-E1 error code or door stuck locked after self-clean cycle. Includes lock motor and switch. Video guide available. 30-minute DIY repair.

Replace worn range drawer glides to restore smooth sliding and eliminate sticking or rattling. Supports proper drawer alignment and movement. Confirm fit.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.