Control Board

• Doesn't shut off

Installed this part and it was working good as new in 15 minutes! Read more

On/Off switch was not working on our GE dryer. An appliance repair person told me he would charge $350 for the part and service. Purchased the part needed from AppliancePartsPros.com for around $130 (including S&H). The part was delivered within a few days and took literally minutes to install with socket set, pliers and a phillips head screwdriver. Read more

Our oven went out because of a power failure while the oven was on. I purchased an ignitor from a local repair place but it still would not work. We were told it could be the control panel. We ordered another ignitor just in case and also the control panel. We put both parts in, turned on the gas and electric and the oven came right on, I am a very happy wife. This company is great, they are not only fast on shipping, there customer service is very concerned about your identify when you order... Read more

Figured same part to be bad - had no power to display board - could not see Control board on web site so I called and customer service gave me the part number to enter into their site and confirm that was what I needed Great service - I have ordered several times in the past. Read more

Display would flicker "Delay" light and then shut down. Replaced control board and door switch. Read more

Called to check with model number and talked to someone who definitely said it was the main board that had gone bad. Revived it in a day and replaced it and my wife and life are happy again. This is where I go to for appliance repair. Read more

1. Turn off the electricity to the dishwasher 2. Unscrew all of the screws on the inside of the dishwasher door. 3. Take off the door and put it aside 4. Loosen the panel that contains the control board, control panel and the door lock mechanism 5. Using a screw driver, push in the small moveable tab in the center of the plastic clip that is holding the control board to the plastic panel. 6. Unhook the ribbon that is attached to the bad control board. 7. Attach the ribbon to the new control... Read more

Purchased a new timer from applianceParts Pros. Simple replacement took 15 minutes, dryer is running like new again. Also, defective timer made in china, new replacement made in USA. It just doesn't get any better than that! Read more

I replaced the Board-Phas and speed control plate since power was not making it to the motor. When I received the speed control plate it had nuts on the upper screws with springs, since my old one didn't have nuts I assumed that the nuts were to keep the springs on until installed. After putting it back together, I noticed that though it worked, the first two settings did nothing. Now, guys, I was desperate, OK. I downloaded the service manual and read it from front to back, and when I got to... Read more

Replaced ignitor. Watch the u-tube videos for removing and replacing the board and ignitor. Read more

I looked on line and found out what might be wrong and then ordered the part from Parts-Pro. They showed us how to install the part. We installed the part and it works as good as new. We have ordered replacement parts from this company many times. We've always had good service from them. I would highly recommend them for all your needs. Read more

The error code implies a faulty fill valve. This was not the case for me. Replacing the main PCB assembly solved the problem. I have run two full loads since the repair with no problems. Read more