Diana March 26, 2024 for Model Number FRSS2323AS0 The Refrigerator started making a very loud vibrating noise. It would stop when you opened the door of either the refrigerator side or the freezer side. It seemed to happen whenever the fan was running. It would start and then stop, sometimes lower and sometimes very loud. Now the freezer is slowly starting to thaw out on the freezer side. What part is it that went out?
2 Answers Diana, this is likely going to be a defrost failure. The defrost heater 5304526032 can be tested for resistance to identify if it is the cause of failure and it should measure 58 Ohms of resistance. Read More...
Dan November 27, 2017 I was looking at 241685701 and have also seen part 241685703. What is the main difference between the two?
1 Answer Hello Dan, While we do not have any specifications on the parts from the manufacturer, it appears that one is for a white unit and the other is for a black. Since we do not have a model number to look up, we cannot say if either will work on your unit. Thank you for your patience and understanding in this matter. Read More...
Charles D. December 27, 2014 for Model Number GHSC39EGPWO The water actuator lever broke and needs replacement. I would like to know to know if part 241685701 will replace it. Thank You
Bob October 07, 2014 for Model Number GHSC39ETEW1 Need to replace broken water actuator on my Frigidaire refrigerator with part #241685701. Have searched and searched for a video showing how to do this on my model. When I remove the drip tray there are no visible screws anywhere that will allow me to continue. My refrigerator is unique in that there are removable insert panels on the front freezer and refrigerator doors. Then there is a plastic sheet with all the ice/water control buttons, but it is not screwed in anywhere. How do I remove this panel so I can replace the water actuator. Your help will be greatly appreciated.
1 Answer Bob, In order to remove the dispenser front you will need to remove the panels on the unit and using a flat blade screwdriver, pry the bottom of the dispenser panel for it to pop off. Once this is done you will remove 4 screws in the housing to be able to pull the housing out to change the lever. Read More...
1 Answer Hello Dan. Use painters tape to surround the fountain control cover. Then use a small screwdriver and remove the spill catcher inner plate. If there are hidden screws on the bottom (just revealed) remove them. They can be a Phillips screw, a 1/4" screw or a T-20 torx screw. If so then try to lift up on the fountain control board and out of place. If not then you need to release the fountain control hidden outer clips to remove the cover. Usually the clips are on the bottom or the sides. Remove the electrical connector and lay aside the cover. Then the inner control to remove and replace the paddle assy. Read More...
Kathleen January 04, 2014 for Model Number GLRS267ZDW4 I need the water dispenser actuator for Frigidaire Gallery refrigerator model GLRS267ZDW4 . What is the right part number please... and is there a part available that will fit and is less costly than an OEM part? Thank you for your help!
1 Answer Kathleen, The part number for the water actuator on your unit is part number 241685701. We are not aware of any type of aftermarket actuators that will work for your unit. Read More...
Robert July 07, 2013 for Model Number GLHS68EEPW2 I'm having a hard time finding the right part # because my Model # GLHS68EEPW2 isn't showing up on your site. I've also looked it up on Frigidaire's site and it says Discontinued. What part I'm needing is the Water Dispenser Lever is broke and I need to replace it. I've found an Actuator that's similar in appearance but it says not for my model #. Can you help? Thanks.
1 Answer Robert, the actuator part number 241685701 is the correct replacement and will work on your model GLHS68EEPW2. Thanks. Read More...
Greg February 24, 2013 for Model Number PHSC39ESSO Broke the water actuator. Looks like I need Part #AP396785; Mfgr #241685701 but cross reference says not compatable with my model #PHSC39ESSO fridge (serial #4A61311533). I see the comment about the above part replacing another number. Am I getting the right part number? Thanks
1 Answer Hello Greg. No, based on the model number you need to order part number 241685703. Read More...
Greg April 14, 2012 for Model Number 253.54662402 How to install water dispenser actuator (part#241685701)
1 Answer Hi Greg. Use painters tape to surround the fountain control cover. Then use a small screwdriver and remove the spill catcher inner plate. If there are hidden screws on the bottom (just revealed) remove them. They can be a Phillips screw, a 1/4" screw or a T-20 torx screw. If so then try to lift up on the fountain control board and out of place. If not then you need to release the fountain control hidden outer clips to remove the cover. Usually the clips are on the bottom or the sides. Remove the electrical connector and lay aside the cover. Then the inner control to remove and replace the paddle assy. part # 241685701. Thank You. Read More...
Rick March 19, 2012 for Model Number glrs267zdw4 I pulled everything out of the door like the answer from a previous question upon installing this actuator. Got it out and went temp install so I can use the ice dispenser and when I go to plug the front panel back the ice maker stays on??????
1 Answer Hello Rick. Based on the information you provided, it sounds like the actuator 241685701 is pressing the micro-switch 241689106 and needs to be adjusted. Hope this helps. Read More...