Bryan April 26, 2022 for Model Number GDF610PMJ4ES The problem started as intermittent, with door kept slightly open for ventilation and while closed/latched, machine would randomly turn on and beep and eventually turn off. It would sometimes lose power altogether for a while, and randomly turn back on. Cycling the circuit breaker would restore power to the machine while hard broke sometimes.... Now the machine is hard broke, no power, no LEDs, cycling door open/closed and breaker on/off does not reset. I confirmed input voltage is present to the machine. Ive tried to hold the start and select cycle buttons for 5-10 sec to reset but it also does not turn on the machine. What else should I check to determine which part to change?
1 Answer Bryan, From your description it does sound like a possible main control board issue, however, I would use the tech sheet packaged with your machine and try running the service mode diagnostics. Proceed with the repairs based on the diagnostics (blinking LEDs)...if the board will not enter the diagnostics then the board will be the issue to start with. Read More...
Terry November 03, 2021 for Model Number GDF620HSJ4SS Dead dishwasher, no lights of any kind at the user display and does not turn on. The main control board is getting power. There is a solid green LED light on the board that is illuminated. Does this indicate the board is good, bad or do you need to do something else to determine if the board is good? Thank-You
1 Answer Terry, the user interface WD21X31902C would need to be tested for 13.5 Volts DC from the black/green wire at pin 1 to the yellow/blue wire at pin 2. If there is voltage, the interface has failed and would need to be replaced. If there is not voltage, the main control WD21X24900C would need to be tested at the same wires located at the connection J722. If the voltage is there, the DC wire harness WD21X23416 has failed. If not, the main control has failed. Read More...
Terry October 26, 2021 for Model Number GDF620HSJ4SS Dishwasher totally inoperative, no lights on display. Unplugged, door carefully/fully closed and it lit up. Thought defective tub side door latch switch so I changed that and unit worked for about a week. Then totally inoperative again. No lights at all. Confirmed power to the unit at the receptacle. Question: is this a symptom of a defective control board, defective UI board, or both? Anyway to diagnose further? Which part would you replace first based upon these conditions? Thank-You very much
1 Answer Terry, the machine control WD21X24900C would need to be tested at the 5 wire connection J722 from the black/green wire at pin 2 to the yellow/blue wire at pin 5 for DC Voltage. If there is not 13.5VDC when power is applied to the dishwasher, the machine control has failed and would need to be replaced. If there is 13.5VDC, the user interface control WD21X31902C would be the most likely failure. Read More...
Rob September 07, 2021 for Model Number GDT545PSJSS The dishwasher before it stopped working completely would randomly beep when the door was left slightly open for ventilation. Then is stopped working, not lights on control panel. I replaced latch, still didnt work, then replaced bottom computer board, WD21X24900 still doesnt work, getting solid green light on board, should it flash or be solid? I have ordered up board under control buttons, was that a good idea? Thank Rob
1 Answer Rob, if the service machine control is sending voltage out to the user interface and there is not a broken wire, then the failure would certainly be in the user control. Read More...
Kevin June 17, 2021 for Model Number DDT595SGJ0WW I need to replace control board WD21X23456 (discontinued). What part is compatible to replace?
Philip April 28, 2021 for Model Number ge I have replaced the door latch and the main circuit board and it still gives the 3 beeps like it thinks the door is not closed. Any suggestions or is it off to the junk yard after only 4 years? Thanks for your assistance...
1 Answer Phillip, We will need to have the model number of your unit to be able to assist with your question. Read More...
Williams April 12, 2021 for Model Number GDT635HSJ2SS My GE dishwasher won't start when press the start button. It gives 3 beeps and the light on the door flashes. I replaced the door latch switch, still the problem is there. I lowered the main control and no LED on the board when the power is on for the DW. Is the board bad and need replacement?
1 Answer Williams, Based on the description it sounds like the machine thinks the door is open, Check the door switches and the wiring connections, if all is good it would then likely be a board issue. Read More...
Lk February 05, 2021 for Model Number GDF610PMJ2ES We need a new control board for our dishwasher model GDF610PMJ2ES. Per GE's site, we need part WD21X23456. However, this is no longer available anywhere (no longer made) In searching repair forums, this part was recommended for our model: https://www.appliancepartspros.com/ge-service-machine-control-wd21x24900-ap6890957.html Is there any way to confirm that this part does indeed work for our model? Thank you
1 Answer LK, the service machine control WD21X24900C is used with the model provided and is recommended by the manufacturer as it is a revised control. Read More...
Al January 21, 2021 for Model Number GE GDT535PSJ2SS I loaded up the dishwasher, pushed the start button and closed the door. The DW beeped 3 times and the yellow light continuously blinks. I removed the kick plate and lowered the main control board and while there was power to the dishwasher(it was beeping), the service LED was NOT lit. Am I looking at a main controller replacement?
1 Answer Hello Al, this sounds like the user interface is failing, it is part WD21X31910. Read More...
Jill December 09, 2020 for Model Number GDF520PSJ2SS IS THERE A HOW TO REPLACE VIDEO FOR THE CONTROL BOARD WD21X24900
1 Answer Jill, Thanks for the question!!! We do not have a video for that part number but we have a video on part number WD21X22276 which is very similar and should help you get the job done. Read More...