James October 14, 2019 for Model Number RS2530BSH I replaced the fan motor, for the coils, freezer was working fine , before repair, frig side not. Fan won’t come on now nor compressor. Lights, on inside, & one light on display panel, flashing, is all that’s working. Any ideas, thanks
1 Answer James, Before you do anything else i would unplug the unit for a couple of minutes then reapply power and see if the control board resets itself. If not tell us what the panel is blinking because it could be the error code. Read More...
Stephanie March 27, 2018 for Model Number samsung RS2530BSH The inside part where door closed from refrigerator to side door of freezer is hot to touch as well as the left outside of freezer. I have looked and it has stated that i may need to replace the fan motor. Do you think this is right? Thank you
1 Answer Stephanie, You will want to pull the unit out and check the condenser coils to make sure that they are clean and check the condenser fan motor to make sure that it is running. If it is not running then test it for 12vdc to it and if there is proper voltage then the fan is bad and will need to be replaced. Read More...
Dale September 07, 2017 for Model Number rs261mdwp/xaa have a samsung refer compressor comes on and there is a delay before fan comes on is this correct operration
2 Answers Dale, Yes that could be normal operations " F-Fan motor usually runs together with the Compressor except the Cool Select Zone function is activated. Once the door is open and closed at high ambient temperature, F-Fan motor put off its operation for one minute. Therefore, you are advised not to take it as an error. If the delay is longer than 1 minute, the voltage between GND in Main PBA and CN 75 #2 is 8-12 VDC. The voltage between GND and CN 75 #2 repeats the change from 7-12VDC to lower than 2VDC. If the voltage is correct, replace the fan motor. Read More...
Dale September 07, 2017 for Model Number rs261mdwp/xaa have a samsung refer compressor comes on and there is a delay before fan comes on is this correct operration
2 Answers Dale, This would be normal operation as they are on different circuits in the control board. Read More...
Adelina G. May 16, 2017 for Model Number RS263BBSH My refrigerator does not work right. The freezer is working just fine. It does not cool the right side correctly.
1 Answer Hello Adelina, You will need to verify the freezer fan is running. If not, either the fan motor has failed or the control board is not sending voltage to the fan motor. If the fan motor is running, you will need to check for a frost build-up in the damper and air return. For a proper diagnosis we would please need you to verify the model number from the units' I.D. tag since it will not come up for us as a valid model number. Thank you for your patience and understanding in this matter. Read More...
Greg May 18, 2016 for Model Number RS261MDWP/XAA Does this mdl. delay starting of the condenser fan motor with the compressor for a period then start? DC motor type confirmed DC not their till a period of time passed. Have svc. manual not addressed. Thanks Greg
1 Answer Hello Greg. No, the condenser fan should be running as long as the compressor is running. Read More...
1 Answer Hello Drew. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Joaquin February 10, 2015 for Model Number RS2630SH the condesor fan motor burned out. the numbers on the motor are IS-27210SCD6A(AC110/127V 60Hz) the housing that held it in place broke as well and also the fan blade. What is the correct part number i need in order to replace the part. Thanks.
1 Answer Joaquin, The part number for the fan and housing is DA97-01949A. The fan blade would be part number DA31-00010D. Read More...
Mark January 20, 2015 for Model Number RS2530BBP When replacing the fan motor part DA97-01949A from the fridge, do I need to remove the fan blade first from the old one? Or can I simply remove the motor and bring it all out, then remove the blade to install onto the new motor i just bought? Thanks, Mark
1 Answer Mark, If you take out he entire assembly you can remove the fan blade after pulling the fan motor out but in some instances you will have to pull the fan blade off first before removing the fan. Read More...
Self-Learner January 09, 2015 for Model Number MODEL: RS2530BSH/XAA My 11-years-old Samsung refrigerator stops cooling. I checked and saw the fan condenser blade didn't spin. Assuming that was a reason, I bought a new, identical condenser blade and motor. But the new fan still doesn't come on. Please help. Thank you! Condenser Fan Motor #DA97-01949A Fan blade # DA31-00010D.
1 Answer Hello. It sounds like the main board DA41-00219K is bad and will need to be replaced on the unit. Read More...