Tiny2399@Gmail.Com June 23, 2018 for Model Number WTW6600SB2 I have just replaced the tub drive shaft, bearings and seals, and the suspension rods. Now I am getting the UL code every time it spins. Will over torquing the shaft nut on the bottom cause this?
2 Answers Tiny, No, not usually, You want the rotor assembly bolt as tight as possible. You do want to check and make sure there isn't a problem with the stator or tub plate or stator plates. Make sure they're installed properly and tightly, and not distorted or "warped" and the bolts are evenly torqued. Then check the wiring and the RPS assembly W10183157 for frayed, loose or damaged wires, and the sensor is properly installed and "snapped" / locked in place on the stator. Read More...
Tiny2399@Gmail.Com June 23, 2018 for Model Number WTW6600SB2 I have just replaced the tub drive shaft, bearings and seals, and the suspension rods. Now I am getting the UL code every time it spins. Will over torquing the shaft nut on the bottom cause this?
2 Answers Thanks for your question, most of the time the problem is in the motor and the single bolt that holds the motor to the shaft. Make sure the rotor part of the motor it is seated properly and is not rubbing against the stator. . Read More...
1 Answer Rod, This issue would most likely be caused by a faulty tub seal which would need the bearing and tub seal kit W10435302. Read More...
Paul April 29, 2018 for Model Number WTW6200SW2 The agitator on our Whirlpool Cabrio Washer has a softner dispenser on top. In all videos that I have watched for repair there was none that show the dispenser. My problem is how do you get it off the agitator ?
1 Answer Paul, To remove the agitator you will just need to pull the dispenser off and once it is off then you will need to remove the bolt inside to remove the agitator. Read More...
Michael March 09, 2018 for Model Number WTW6600SW2 What bearing kit is needed for my washer and can the special tool needed to replace it be rented?
1 Answer Hello Michael. You need to order part numbers W10435302 and W10447783 to repair the unit. Thank you. Read More...
2 Answers Hello Frank. You will need to order W11132267 for the bearings and shift needed. They are part of the gearcase. Thank you. Read More...
2 Answers Hello Frank, You will need to replace the gearcase W11132267 since the tub seal and bearings are a part of this assembly. Read More...
Debbie March 05, 2018 for Model Number MVWB750WR0 The bearings have needed to be replaced in our Maytag Bravos washer a couple of times already, so we already have the needed tools and some parts. I need the bottom bearing, the top bearing, and the tub seal. Is it possible to only purchase these 3 items? Thank you, Debbie Bishop
1 Answer Hello Debbie. No, you have to order the kit W10435302 for the parts that are needed. Thank you. Read More...
Dana March 05, 2018 for Model Number MVWB750WQ0 I just installed the bearing and seal kit. How long does the adhesive need to dry before running the washer? Thanks.