Customer Questions and Answers for Small Surface Element by Whirlpool

Roy, Unplug range or disconnect power. Pull the range forward so you can access the two end cap screws. To remove the electronic oven control (EOC) assembly on slide-in models: Remove the two screws from the sides of the left and right end caps. Open the oven door and remove the screws from the bottom of the control panel. Pull out on the bottom of the control panel, unclip the top edge from the bracket, and rotate the control panel forward so you can access the components. Label and ) Disconnect the wire connectors from the electronic oven control board and the ribbon cable connector(you could also take a photo). Remove the screws from the left and right side trim, and then from the rear trim. Remove the trim pieces from around the cooktop glass. Remove the cooktop glass brackets from the left and right sides of the range. Lift the rear of the cooktop glass off the range, slide it out from under the front control bracket, and remove it. ) Label and disconnect the wires from the limiter and element terminals. Lift the element and limiter and remove the spring clips from the support rail slots. Reverse the proceure to install the replacement part.

Hello Slava. No, you have to replace the whole element to replace the temp sensor.

Hello HL. You will need to order and replace the switch W11122012 for that element.

Hello Jody. Sorry, the part needed Y0306222 has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part.

Hello Rober, This will either be the elements or the infinite switches.You will need to troubleshoot to determine the exact cause of the issue. This will be either WPW10242957 or WP3148952 for the left rear and W10823699 or WP3148953 for the right rear.

Hello Angie. You will need to order W10823708 for the left rear element.

Hello Steven, This light can come on due to either a bad limiter which is not available without the element assembly or a failed infinite switch.

Peng, the right front element is part number W10823698 and left rear is part number W10823699. Here are the instructions to remove/replace parts. Hope it helps. Thanks. 1. Unplug range or disconnect power. 2. Remove the control panel from its' sub-chassis and rotate it forward onto the cooktop glass. 3. Remove the five screws and flat washer from the control panel sub-chassis. 4. Move the control panel back into place over the chassis, then lift the front of the cooktop assembly, and prop it up with a piece of board so that you can access the components. CAUTION: Be careful that the cooktop does not accidentally fall.

Manny, the right front element is part number W10823699 and left front element is part number WPW10242957. Thanks!

Donna, the large left front element is part number WPW10242957. Thanks!