William May 29, 2020 for Model Number 10651123211 Ice maker mechanics are working but not producing ice. The arm ejector, motor and arm shutoff are running continuously. The in-door water is working properly. Just won't produce ice. Does the water inlet valve need replacing?
1 Answer William, based on the information provided, the ice maker WPW10300022 has failed. The ice maker should not go through a continuous harvest cycle over and over again as this indicates a failed motor. This would also prevent the ice maker from sending voltage to the water valve to allow water to reach it. Read More...
Michael March 16, 2020 for Model Number WRS555SIHZ00 The ice maker is not filling with water. I replaced the ice maker. I used a hair dryer to melt water fill line. The solenoid for the ice maker side of water inlet valve reads 158 Ohms. Is the solenoid bad? Solenoid is getting power. The only thing I have not replaced is the ice bucket door switch and ice maker power switch.
1 Answer Michael, If the solenoid is getting power when the icemaker calls for water then the solenoid will need to be replaced. Read More...
Schumpert May 27, 2019 for Model Number WRS325FDAB01 Replaced water valve. Little water coming out of water dispenser on door. Have not heard ice maker filling up.
1 Answer Schumpert, I believe this unit will run water without the filter. Remove your filter and see if the water fill returns to normal. It sounds to me like a water filter or water filter housing issue. Read More...
1 Answer JT, No, to the best of our knowledge the compression fittings on the WPW10179146 / W10179146 Filter Valve Assembly, are designed to secure and seal the "plastic" or "plex" water lines that are internal to the water reservoir, water dispenser and ice maker. The water tube adapted for connection to the water supply line is WPW10350007 / W10350007 Tube, Filter Inlet, Read More...
Senen S October 13, 2018 for Model Number MSD2574VEQ10 No water to dispenser neither to ice maker , filter replaced and still the same.
1 Answer Senen, While it is possible that the water valve is faulty you will want to check the main supply to make sure that it is getting water to the unit. If there is then this will either be the valve or the water filter housing that is faulty. Read More...
Scott Bray July 17, 2018 for Model Number KSRJ25FXMS03 Ice maker has stopped filling with water, front panel water dispenser still works though. Replaced the 2 circuit boards on either side of the door, still not working. Feel like there would be a relay or something that tells the valve to open to let water into the tray. Unable to track that down in the illustrations.
1 Answer Scott, You will want to cycle the icemaker and check at the water valve to ensure that there is 120 vac to the Valve. If there is power to the valve but not coming to the icemaker then this will be a faulty valve. Read More...
Mike H. January 11, 2018 for Model Number WRS325FDAM02 When my ice mold is filled by the water lines, the ice maker drips water into the ice bin, creating a giant frozen mess.
1 Answer Hello Mike, You will need to verify the water pressure that is supplied to the unit since the water valve is closed by water pressure only and has no internal spring to aid in its' closure. If 40 to 90 PSI is present, you will need to change the water valve WPW10179146. Read More...
Chance December 13, 2017 for Model Number WRS325FDAM Bought a floor model Whirlpool side by side with door water and ice. after installing water line and turning on i opened the freezer and water was pouring out of the ice maker and down into the bin, as if the sensor wasn't stopping the inlet valve. so not sure if its the valve stuck open or the ice maker?
1 Answer Chance, If you had to turn the water supply off at the faucet, then the fill valve is stuck open. If you had to remove power to the refrigerator to stop the water flow, then the ice maker fill circuit is at fault and you'll need to replace the ice maker. But first check to see that there are no damaged wires or loose faulty connections to the ice maker and the fill valve. Read More...
Charly September 19, 2017 for Model Number WRS322FDAB00 Ice maker won't dispense water and the chute behind the ice maker keeps freezing up. I have unplugged the fridge and let it thaw out for a few hours but it freezes right back up. what could be causing this?
1 Answer Hello Charly. You will need to check and see if the water valve WPW10179146 is bad and will need to be replaced on the unit. If it is bad, it will cause the freezing issue and can cause the issue with the dispenser as well. Thanks. Read More...
Rocky May 09, 2017 for Model Number MSD2272VES00 My ice maker has icicles hanging from it and it creates one big block of ice, so I changed the inlet water solenoid but that did not fix it. Any suggestion?
1 Answer Rocky, The part that would be needed for the icemaker having icicles hanging from it will be the icemaker WPW10300022. Read More...