Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix a washer that won't start or lock with a new door strike. This latch catch secures your door during cycles. Simple 2-minute DIY repair with a screwdriver.
Just removed the old and put on the new,simple.On this Fridgidare washer you should lift the door as you close it which should make the striker last.. Read more
Washer won't spin or drain? Error code E47? The door lock assembly often causes these issues. This moderately easy repair typically takes 30 minutes.
I ran a diagnostics check on the washing machine and came up with the error code E47 -Board thinks the door PTC circuit is open in spin. The washer thought the door was open and would not finish the spin. I was left with a washer full of very wet clothes. This repair was SO extremely easy. I only needed to uses a pair of needle nose pliers and a screw driver. It took less than 10 minutes, start to finish. Now the new door lock assembly registers correctly and my clothes are completely... Read more
Washer won't drain or spin? A clogged or failed drain pump is the likely cause. This part removes water from the tub between cycles. DIY repair in 15-30 minutes.
So, Saturday, the washer wouldn't drain, yes, I tried the Drain/Spin cycle. So I took the clothes out, rinsed them out twice in the laundry sink and dried them. After a quick Google search, I came to the conclusion that the pump was bad and ordered a pump, $125. Over the course of the next four days, expecting the new pump on Thursday, I baled out the washer, pulled it out from the wall and propped up the front (it's HEAVY), removed the front access panel, removed the drain inlet and outlet... Read more
Shock absorber kit for front-load washers. Includes 2 absorbers, pins, and hardware. Replace when broken, cracked, or worn to restore stability.
I watched the video posted by Jerrod Sessler on yellow van handyman.com. Then I had to unstack the dryer from the washer, remove all covers, disconnect all hose connections, shock mounts and springs and remove the tub assembly. Then I disassembled the tub assembly and remove seal and both bearings from the rear half. At this point I cleaned everything. I installed new bearings and seal, installed the basket and assembled both tub halves using a new gasket and silicone, and reinstalled the... Read more
Fix washer leaking, no water filling, or poor rinsing with this water inlet valve. Controls water flow during wash and rinse cycles. DIY repair in 30 min.
After tracing the water dripping back up through the inside of the washer I found the water dispenser inlet valve was leaking. I watched several videos to make sure I understood what was involved. I contacted a local parts company to get the part. I also searched online for the part. I found that AppliancePartsPros.com had it cheaper. I ordered late in the afternoon and it arrived the next day. It was fairly easy to installed and saved me a minimum of $99 "diagnostic" fee plus whatever the part... Read more
Flexible gasket sealing washer door to drum, preventing leaks during cycles. Replace when torn, leaking, or showing mold buildup. Confirm fit.
Fixed by replacing the washer door seal "Bellows". Once again AppliancePartsPros comes through with the right part at a great price. It took quite some time to install because putting the inside spring back on the bellow was difficult so I needed to remove the top and front door of the washer to get better access. A set of 3 or 4 plumbing clamps are highly recommended to get that spring back on (I went to the store and bought some). If you search YouTube about replacing the bellows on your... Read more
Replace your washer's cracked or broken outer door panel. This white plastic cover protects the door frame and attaches at the hinge. Restores appearance.
I took the door assembly apart by removing the 7 screws on the inner door and the 2 on the striker. I removed the hinge from the washer so that I could place it inside the door when I put it back together. This is much easier then trying to reassemble the door while the hinge is attached to the machine. Once I lined up all of the pieces properly, I screwed it back together and remounted the striker. I then put the entire door back on the machine by screwing in the three screws that hold on... Read more
Fix a washer leaking from the top or filling when not in use. This water inlet valve controls hot and cold water flow. Easy 30-minute DIY repair.
It was really easy to fix. I just took a screw driver and gently pried up on the top of the clothes washer to open up the top. Then the mixing valve was easy to access. I removed the two screws holding and unplugged the the wires. And pulled the old one free. Then reversed the process to install the old one. Less than thirty minutes start to finish. Read more
Fix a broken or cracked dispenser drawer handle that won't open properly. Simple snap-in replacement takes minutes. Fits front load washers.
I called Appliance Parts Pros and they sent me my frame for my washing machine. This company needs 10 stars. They were excellent and very polite and very knowledgeable on what needed to be ordered. I would never purchase another Frigidaire item as the quality is not there. I would recommend looking at this site for any parts needed for anything. It was a pleasure talking to them and the item shipped very fast and was here in 3 days. Thank you Appliance Parts Pros you are the best. Read more
Secures the door boot seal to prevent leaks in front-load washers. Replace if rusted, broken, or seal is loose. Verify fit with your model number.
Y'all! This video made fixing my washer easy peasy. The service repair man wanted $352! I paid less than $200 for the parts. I also called around and appliance parts pros was by far the cheapest option. The shipping was unbelievably fast. (Faster than my amazon prime!) Read more
Replacement outer door panel for front-load washers. Covers the exterior surface of the door. Order when your panel is cracked, dented, or damaged.
Removed and replaced parts about 30 minutes of work. No leaks Read more
Washer won't drain or has standing water? This drain pump actively removes water after each cycle. DIY-friendly repair, typically takes under 20 minutes.
Replaced pump. All components are accessible from the front of the machine. You have to remove two screws in the back that hold on the top cover, then slide the cover back. This will allow access to the screws that hold on the control panel. Remove the control panel (unplug cable), then remove the spring/wire that holds on the door bellows to the front panel (removing and installing that is the most difficult part of the job) and carefully remove the bellows from the front panel. Then remove... Read more
Front-load washer door bellow forms watertight seal to prevent leaks. Replace if cracked, torn, or moldy. Confirm fit with your model number.
Removed old bellow following procedures found on relevant Youtube videos. Reinstalling however was more of a challenge. Getting the rear seal of the new bellow on the washer housing was not as easy as the videos indicated. The key to that process is being sure the seal is well lubricated which is not quite apparent from the videos but is essential success. Once the rear seal is installed, reapplying the rear spring was accomplished with the spring clamps as per the videos. Be sure to... Read more
Inner door frame for front-load washers. Secures door glass and seal, maintains alignment. Replace if cracked, broken, or causing door to sag or misalign.
Removed the door at the hinge (3 screws). Removed the screws on the inside of the door holding the three sections together. Found one pin on the hinge broke OFF. Ordered parts. Arrived in 2 days. Re-assembled door and hung. Read more
Detergent drawer broken, cracked, or won't open? This drawer holds and dispenses detergent during wash cycles. Simple snap-in replacement, no tools needed.
Got online and searched for part by washer model number. Found AppliancePartsPro.com. They listed diagram of part. I ordered it online and received it next day with no extra charge for fast delivery. My husband attached cosmetic drawer cover to detergent drawer part we ordered in a few minutes. It fits and is working! Speedy service was appreciated. Read more
Fix a washer that won't fill, overfills, or shows E35 error code with this water level pressure switch. Moderate DIY repair takes about 1-2 hours.
Water valve not closing all the way. Water keep entering washer even with power cord unplugged. Parts I ordered fit perfect. Ordered on Thursday night , parts there Saturday. Great service and shipping. Thank Read more