Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Oven won't heat properly or overheats? A faulty temperature sensor may be the cause. Simple 15-minute DIY repair with basic tools and our video guide.
I have a Whirlpool RBS245PDQ12 wall mount oven. Gathering information from AppliancePartsPros.com resulted in two possibilities: The Thermal Switch or the Control Panel. Talking with Appliance Parts Pros led to testing the Oven Temperature Sensor. It's supposed to test at 1080 Ohms at 70 degrees Fahrenheit. Mine tested at 960 Ohms so I knew it was bad... I found the service manual on the top of the Oven on the left behind the control panel. It has values for testing (Ohms of resistance)... Read more
Fix a microwave door that won't stay open or falls shut with this right-hand torsion spring. Moderate DIY repair—replace both springs at once.
Removed the Microwave from the wall, then had to almost completely disassemble the sheet metal surrounding the microwave unit itself. Lots of screws and wires to work around. Takes 2 people to remove the microwave and set it on a stand outside of the wall unit. Once you get to the light bulb, the replacement is easy, just very challenging to get to the light bulb. Read more
Replacement inner glass panel for oven doors. Installs between outer and inner door layers. Needed when cracked, shattered, or broken. 17x10 inches.
The most difficult part was figuring out how to take the door off as the manual instructions were not clear. Thank you, YouTube for your help. This door doesn't have the more modern release latches. You open the door all the way and stick Allen wrenches into the holes that appear by the joint of the latch. When you close the door to 3/4 or 7/8 closed, the latches are released from the unit and by holding the sides of the door, you pull it out. The whole replacement would take around an hour,... Read more
Oven won't heat after self-clean cycle? A blown thermal fuse cuts power when temps spike. Easy DIY fix—disconnect power, test with multimeter, replace.
This is for the Whirlpool in-wall double oven GBD307PDS10. No power and the door locked after the shutdown before the self-cleaning cycle was over. I watched some video and this is a known issue the fuses blow during self-cleaning. I opened the door with a 90-degree hook, an easy task. Took doors off (watch video from others), unscrewed from the wall, and made a very small platform. and took the oven out (need two people and take the doors off first. The doors are heavy and you won't lift the... Read more
Illuminates the microwave interior for visibility during cooking. Replace when burnt out or dim. Confirm fit with your model number before ordering.
Replace your microwave's broken or cracked glass turntable tray. This circular rotating plate sits on the cavity floor to hold food during cooking.
Replaced it. It took over 4 months to get the part due to a lack of inventory. I initially ordered from another supplier who after several months sent an incorrect part. Shifted to AppliancePartsPros. They confirmed the inventory shortage and gave me a two-month delivery estimate. About a month into the wait, they provided an update. The next update was noticed. That the part had arrived and was being shipped. Part arrived on time. Correct part, well packed, took about a minute to unpack... Read more
White acrylic spray paint for appliance exterior touch-ups. Restores worn, chipped, or scratched surfaces on refrigerators, ranges, and more. 13 oz can.
Replaced It With New One Read more
Replacement mounting screw for securing handles, panels, and internal components. Needed when original screws are stripped, lost, or broken during repairs.
This was actually one of the easiest fixes I’ve done. All that was required was to remove 3 screws to remove the broken part. I used a pair of pliers to remove the moisture sensors from the broken part to the new one. Read more
Touch-up paint for covering scratches, chips, and minor blemishes on appliance exteriors. Restores appearance and protects surfaces when finish is damaged.
Touch up paint Read more
Oven not browning or broiling? A faulty broil element won't heat up. Easy DIY fix—disconnect power, remove screws, swap wires. Video guide included.
Installed new heater element. Read more
Microwave won't start or shows door error? This door switch signals when the door is closed so power flows to the magnetron. Moderate DIY repair, 30-45 min.
I'm a 56 year old divorced woman. I started doing these kinds of repairs to save some money and honestly, to see if I could. So yes, if I can do it, it's not that tough to do. My microwave is built in above the stove - getting it down and back up was the hardest part of the job. An extra pair of strong hands really helps-for anybody, not just a 56 year old woman. The actual repair was pretty easy. Most likely problem was pretty obvious after a little research. Easy to take off cover, get... Read more
Oven blower making grinding or humming noise? This lower convection blower motor circulates air during cooking. DIY repair takes about 2 hours.
Ordered the new fan (blower) from AppliancePartsPros. It arrived 3 days later. Pulled the wall oven out of the wall, removed the sheet metal back and removed the noisy fan. Installed the new fan, reinstalled the sheet metal back, shoved it back into it's place, turned the power back on and viola!, much quieter. Read more
Fix a slamming or heavy microwave door with this right-hand torsion spring. Moderately challenging repair takes 1-2 hours with basic tools and care.
Turned power off. Unscrewed the two vertical trim pieces and the bottom trim piece(stainless). Slid microwave out a few inches. Unscrewed the two screws on the inside of the door toward the top that are recessed in the black plastic. (Besure to hold the door assembly together while doing this so you don't accidently drop the glass door). This exposed the bottom two springs. Usually one has a paint mark on the end to tell them apart. Replaced and put back together. Read more
Illuminates oven cavity for monitoring food while cooking. Replace when bulb burns out or oven interior is dim. Verify fit with your model number.
One would think replacement appliance light bulbs would be a staple In Service departments of appliance stores, not so. I decided to travel to several local parts and service departments to pick up six of the little bulbs. Guess what? no one had them in stock! Time, energy spent - mission NOT accomplished. Once again, I turned to AppliancePartsPro.com. Et voila! They bulbs were in stock AND arrived the next day! YEA! Fast, simple service. Instant Success! Who could ask for anything more? Read more
Fix a microwave door that won't stay open or slams shut. This torsion spring provides counterbalance for smooth door operation. DIY-friendly repair.
We replaced the middle glass and spring by taking the door apart with no problems. Read more
Replacement hinge for oven doors. Allows smooth opening and closing. Replace if cracked, bent, or causing door misalignment. Sold individually.
For the third time in four years, the hinges failed on my KitchenAid wall oven. The appliance is out of warranty and KitchenAid does not consider this to be worthy of any recall. I was tired of paying the appliance repairman to change out the hinges, so I ordered the part online. Appliance Parts Pros is an awesome site for identifying the part you need, and they deliver quickly. Note that you probably need TWO hinges--they do not come as a set--and KitchenAid likes to make their model numbers... Read more