Gs563lxss1 Whirlpool Parts

Ordered a replacement panel. Item arrived exactly as described. Used the Youtube instructions. Took all of 5 minutes to replace. Thanks! Read more

Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more

• Won't start

I purchased a new igniter for the bake assembly and found that it, unfortunately, did not resolve my problem. I measured the resistance of the different points on the gas valve and it was reading within spec so I then purchased this spark module and it did the trick. My gas range is a Kitchenaid kgsk901sss02. I had a LOT of trouble finding where the spark module is located, and eventually found a schematic that shows it's location behind the front control panel of the oven. Upon taking the... Read more

After receiving my parts from appliance parts pro and seeing it was a perfect match, I removed the burner heads, put on new top, and screwed the heads back on. It went very smoothly Read more

Removed three screws holding trim on bottom of oven door, removed rusted trim, installed new trim, reinserted the three screws. Stove looks new again! The experience with AppliancePartsPros was outstanding, representative I spoke with rechecked the part number I provided to make sure it was the correct part. The part arrived the following day, packaged to ensure it did not become damaged during shipping. Excellent experience! Read more

Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more

Kit arrived promptly. it took help of a friend and 45 minutes to install Read more

Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more

Replaced the hinge receiver with a new one. The old one was bent slightly inside where it could not be seen. I think someone pushed the door down to far or fell on it. 2 screws to remove it, take out storage drawer and reach up little ways to remove and replace the receiver. Replace the 2 screws. The receiver comes with 2 screws but I ordered an extra ( never used it ). The sides of the receiver were spread just a tiny bit but were enough to cause a problem. Read more

• Little to no heat when broiling
• Gas igniter glows, but will not light

Called a repairman and he told us we needed to change a bunch of parts and would cost over $400! Decided to do some research online and found suggestions to replace the spark igniter. Decided to give it a try. Took about 10min to replace and oven is now working perfectly, for a total of $30! Read more

Overall the fix wasn't too hard. The challenge was putting the oven door back together and holding it together while trying to tighten the screws. Enlisted my wife's help to hold the door and at first the handle screws wouldn't tighten. My cordless screwdriver's battery was under-charged. Once I switched batteries I was able to tighten the screws. Seemed like I needed to push too hard (my wife freaked "not so hard you will strip them!") however pushing hard was what was needed. Both screws... Read more

Installed it according to video watched. Read more

I knew for sure that the hinge with the large spring was damaged, but elected to replace both hinges and receivers. Replacing the parts was fairly easy and would have taken me less then an hour. This model has thin metal covers over the hinge assemblies. I found that squeezing in the sides of the covers help to hold them in place on the hinge while reassembling the door. My only difficulty was putting the door back on the oven. It took a little maneuvering but I managed to get it. Now the door... Read more

The problem is a finicky ignition system, Direct Spark Ignition. Apparently Whirlpool redesigned the igniter/burner assembly slightly to make it more reliable. The repair is very easy. Turn off power, but you don't need to turn off gas. Remove oven bottom and flame spreader, then remove burner/igniter assembly, one screw at front, one at back. Lift out burner assembly carefully to avoid stretching wire. Pull electric connector from pin on burner/igniter assembly. Vacuum to clean oven. ... Read more

Took oven door off and replaced part. While I had the door off I removed the front glass and cleaned it and the 1st interior glass window. Read more

The replacement part was identical, arrived quickly as promised, and took only a couple of minutes to install. Excellent service. Very happy with the end result and the whole process. Read more