Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals. Read more
Replacement water feed tube that delivers water to the upper spray arm in your dishwasher. Replace if cracked, split at seams, or leaking due to wear.
After we saw that progressively our dishes were not getting clean we investigated the condition of the spray arms and this upper feed tube assembly. We found a huge crack on the side of this piece and new not enough water was getting to the arms. We also noticed a build up of soap and lime. So we ran a cycle of vinegar and sprayed the filters and arms with lime-off-sprayed them out with a air hose "completely". Many of the small pieces of lime will clog the holes in the spray arms. Attached the... Read more
Fix a dishwasher that won't fill or run with a new pressure chamber. Controls water level by sensing pressure. Moderate DIY repair with video guide.
Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more
Dishwasher cycles running too long? A faulty turbidity sensor can't detect water clarity, causing extended wash times. Moderate DIY repair restores normal operation.
Replaced the turbidity sensor. I watched the video on how to replace the sensor. It took me a little longer than what service rep. said. But I finely finished the repair and now my wife has been using the dishwasher for the past week. I kept checking for leaks but so far so good. Thank you Appliance Parts Pros for your help. I installed the sensor on 08/18/2020. Don Read more
Fix a dishwasher that won't fill, overfills, or leaks from the base. Water inlet valve controls flow into the tub. Moderate DIY repair, 30-45 minutes.
Bacteria buildup in the venting assembly and drain hose. Replaced them and it's back to normal Read more
O-ring seal prevents leaks between dishwasher components. Replace when you notice water drips or moisture buildup. Confirm fit with your model number.
WE replaced the drain pump and it still wouldn't drain sometimes. Finally we realized that the drain hose wasn't the correct bosch hose and the rubber was starting to bend and kink where it went through the hole to under the sink.So we bought the drain hose and replaced. Read more
Secures the dishwasher sump or sump cover to the tub for a tight, leak-resistant seal. Replace if missing, stripped, or damaged to restore stability.
Water inlet fill hose connects your dishwasher to the home water supply. Replace if cracked, leaking, worn, or damaged to restore proper water flow.
Replaced the Water Inlet Valve and Drain Hose. Read more
Fix a dispenser door that won't stay closed or rinse aid light staying on. Complete assembly includes latch, spring, and gasket. DIY-friendly repair.
Replaced the dispenser. The video on your website was most helpful and made replacement very easy with the little tips to show removal and install of new part. Read more
Dishwasher won't stop running or draining? A faulty float switch may be stuck, triggering continuous pump operation. Simple DIY fix in under an hour.
Replaced the defective float switch. Read more
Detergent not dispensing during wash cycle? This actuator arm with spring releases the detergent cup at the right time. Moderate DIY repair.
Ordered a replacement control panel and installed it according to the AppliancePartsPros.com YouTube video. Read more
Soap dispenser door won't open? This dishwasher wax motor actuator controls detergent release. Moderate DIY repair, takes 2 minutes to activate.
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more
Gray plastic clip that secures folding tines to the dishwasher rack rail. Snaps onto the rack assembly to hold flip tines in place. Replace broken or missing clips.
After having seen the video I installed the new lid and it worked. Read more
Fix grinding noise, poor water circulation, or leaks at the pump base. This rear pump housing supports the impeller and bearing. Moderate repair.
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger. When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed... Read more
Fix a dishwasher door that won't close or latch properly. This latch and strike plate assembly restores secure door closure and safe operation.
Replaced check valve, was broken off and plugged the drain Read more
Tall item spray head that attaches to the upper feed tube in your dishwasher. Replace if cracked, broken, missing, or won't lock into place properly.
I replaced both the door seal and the lower door seal. The lower seal was a bigger job and I used a number of YouTube videos to walk me through it. It was a pain, but it worked. Had I called the appliance store the following would have happened - After a week they come out and verify, yet it is leaking and they will need to come back in a week or so after ordering parts. Instead I did t myself, got the parts in 2-3 days and saved some money. There are very good resources for finding parts and... Read more