Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix dirt particles in ice or jammed dispenser with this ice bucket and auger assembly. Includes bucket and rotating auger. Easy DIY install in 30 minutes.
Screwdriver Read more
Ice dispenser only making crushed ice instead of cubes? This solenoid valve kit fixes the cube/crushed ice selector. Easy DIY repair with video guide.
This was a two and half year issue as different things failed at different times. I would get one part, then another would fail. Ultimately, I got to a point where what failed, I hadn't been ordered the part yet. The seal on the freezer door took three bathing's before it plumped up and un-creased. The directions on the box it is shipped in said to heat the seal up in hot water then cool it down with tap water. I didn't need to do that. It took a lot of massaging of the seal, but... Read more
Freezer not cooling or making buzzing noise? The evaporator fan blade circulates cold air. Easy DIY fix in under 5 minutes—simply pull off and press on.
I used a set of ring pliers to remove the old retaining ring, then spread the plastic ribs around the fan motor shaft with a small flat bladed screwdriver to ease removal of the old fan blade. I reversed the process to replace the blade, gently tapping a socket from my socket wrench set placed over the motor shaft and ribs with a small rubber mallet. I stopped when the shaft protruded about 1/8" beyond the plastic ribs of the new fan blade, then installed the new retaining clamp ring with the... Read more
Plastic water line that connects the water inlet valve to the ice maker. Replace if cracked, leaking, or damaged. Includes installation video.
Fridge is 14 years old, ordered the water valve assembly and hose. Removed and replaced both Read more
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,... Read more
Ice buildup in freezer? This defrost heater and thermostat assembly melts frost from evaporator coils. Moderate DIY repair restores proper cooling.
I replaced defrost heater with thermostat. It is a very easy and there is YouTube tutorial video for that. Read more
Refrigerator not cooling or compressor overheating? A failed condenser fan motor is often the cause. This repair takes about 10 minutes with basic tools.
Resurched the Needed part. Found Appliance parts pro had the best price. Ordered the part at 2:47pm pm on Thursday. Confirm email immedately received. Shipped email received in less then two hours. Item dropped at my door 1:00pm next day. I only paid for regular shipping. Very impressive. Great job, Thanks Read more
Fix a refrigerator that won't start or clicks repeatedly. This compressor capacitor stores energy to start the motor. DIY repair typically takes 30 minutes.
Replaced overload, and capacitor Read more
Ice dispenser stuck on crushed or not dispensing? This armature kit connects the solenoid to the chute door. Moderate DIY repair with video guide.
Replaced the water supply valve...boom! Read more
Ice dispenser door won't open or solenoid buzzing? This door solenoid assembly controls the ice chute flapper. Moderate DIY repair with video guide.
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside.... Read more
Secures the ice chute flapper in your refrigerator door. Replace if cracked or missing to restore proper sealing and prevent frost buildup. Verify fit.
Replaced springs, flapper assembly and ice door retainer as described in videos and it was easy. So far so good..water dispenses. Read more
Ice dispenser not working or making humming noise? This auger motor drives the crusher mechanism to feed ice through the chute. Moderate DIY repair.
I watched the help videos first, then ordered the parts, and installed all items as in the video. Read more
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge. Read more
Black hex washer screw for securing range components like door trim, control panels, and internal brackets. Replace missing or stripped screws during repairs.
I ordered the part and was impressed to receive it within two day! I didn't need the screws I ordered (which I ordered just in case) but the trim was put on with no problem and my oven looks brand new again! Thank you! Read more
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
New parts. Read more
Internal water storage reservoir for refrigerator dispensers. Installs inside the fresh food compartment. Replace if cracked, leaking, or split.
This part was easy to install by following the directions from other users here. As long as you get the right hoses connected in the right places, everything else was straight forward. Takes a few minutes for the tank to initially fill and pressurize and clear the air in the line and then you're on your way to clean fresh water! Read more