Need Help?
Call or text
Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.
Prevents water leaks at the bottom of your dishwasher door. Replace if cracked, worn, or water pools near the door hinge. Confirm fit with your model.
I bought the door and bottom seal and was already to go. Appliance Pro got the parts to me in 2 days. I read an article that said if the spray arm holes are blocked that this could cause a wave in the dishwasher that could cause the water to fly up to the inlet used for drying and the water could run down between the front and inside door appearing to be a leak. I checked and my spray arms were indeed blocked. I pulled them out, cleaned them up, reinstalled, and low and behold that was appeared... Read more
Replacement wheel for dishwasher racks that glide in and out. Snaps into place on upper or lower rack. Needed when wheels are broken, missing, or worn.
I changed the control board (00498022) in the door of my Thermador dishwasher. Thermador, Bosch, and Siemens all use the same board for the indoor controls and display. This required a #15-star head driver to remove the screws. I used an impact wrench (set to a low torq setting) to speed things up. There are approximately 12 screws to remove. Two are long. The rest are short. Be careful to hold the door together as the last screws are removed. Everything comes apart easily and you do not... Read more
Fix a dishwasher that won't fill with water or leaks when not in use. This water inlet valve controls water flow during the fill cycle. DIY repair.
Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more
Fix dishwasher not draining or foul odors with a new check valve. Prevents dirty water backflow into clean dishes. DIY-friendly repair in 1-2 hours.
Removed water out of basin, down to the last inch.. Watched water rise slowly, and felt temperature, warm. This told me it was supply water. Ordered replacement part, two days just as mentioned, Removed as per video. Also choose to replace the waste line check valve, to affordable not too. Working great, except the wood floor not so happy with. One thing at a time. Thanks Read more
Fix a rinse aid door that won't stay closed or causes leaks. This dishwasher dispenser door with gasket snaps on in minutes. Easy DIY repair.
Twist the old one out, insert tab, twist until other side snaps in. Easy as pie after watching the video! Read more
Secures tines in your dishwasher rack to hold dishes in place during wash cycles. Replace broken, cracked, or missing clips for proper rack function.
I ordreded the tine clip kit. APPros was the least expensive, even with the shipping charge, and I had it in two days. Replacement piece snapped into place with very little difficulty. I also have extras from the kit so I am set if another breaks. Read more
Detergent dispenser door won't stay closed? This latch secures the detergent cup during wash cycles. Simple DIY repair with video guidance included.
After having seen the video I installed the new lid and it worked. Read more
Fix a dishwasher door that won't latch or stay closed. This door latch assembly secures the door during operation. DIY repair in 15-30 minutes.
Replaced with new latch, took about 5 minutes. T25 torx screwdriver and flathead screwdriver needed. Read more
Replaces cracked, kinked, or leaking dishwasher drain hose. Connects unit to household drainage system. Essential when hose is damaged or worn.
Ordered replacement drain hose, left hand panel of dishwasher removed (remove 2 screws in front left trim panel & friction fit clip at top back then slide up & off. This reveals the O-ring drain hose connection point. You need to remove the retainer block where the hose exits the appliance. Old hose pulls out and new hose pushes in. In the end a very easy installation. Most of the time spoent here is removal & reinstallation of dishwasher back into position - the actual hose swap takes 10 mins Read more
Fix a detergent dispenser door that won't stay closed or pops open during the wash cycle. This lid replacement is a simple DIY repair with no tools needed.
Plastic bushing that guides and supports the dishwasher door hinge assembly. Replace if cracked, broken, or worn causing noisy or misaligned door movement.
Checked out the AppliancePartsPros.com online parts/assembly diagrams for our Bosch dishwasher model and ordered the two sided set of new springs + connector ropes + connector-to-door ... plus a couple of other relatively inexpensive adjoining parts that might have become worn over time, just in case they were needed. The extra parts arrived in two days with standard shipping. Called about the "back ordered" primary set of parts (which had been listed as being "in stock" when I placed the... Read more
Secures the hose between pump and heater in your dishwasher. Replace if loose, damaged, or causing leaks. Confirm fit with your model number.
On my Bosch she55m15uc/64, the cycle would take 3-4 hours, with the machine stuck on "1 minute" for a long time. The interior was getting moldy and smelly, and the dishes had a white film. At first, I thought it was the heater relay on the control board, but I pulled that relay and it seemed to be working. I could get an ohmmeter on the heater element without taking the bottom off the dishwasher, and the resistance was infinite. Replacing the heater did the trick. On my unit there was a... Read more
Fix a dishwasher that won't spray water or makes humming sounds. This circulation pump and motor assembly repair is lengthy but not difficult.
Dishwasher made a humming sound but no water was circulating around. Searching around, I decided that it was either the inlet valve or the pump/impeller. I started with the inlet valve since it’s an easier repair. It didn’t work, no problem, now I have a spare. I then changed the pump and motor assembly. When I got the old one out, the impeller was broken along with a crack in the plastic housing. The repair took about 3 hours following along with the video. The dishwasher now works like... Read more
Secures flip-up tines to your dishwasher rack. Replace this small C-shaped clip if broken, cracked, or missing to prevent tines from flopping around.
Easily installed the side mounts and put new trim around the opening. Read more
Dishwasher won't fill or keeps overfilling? The float switch detects water levels for proper filling and draining. Accessible repair in under 30 minutes.
I checked continuity at the float switch since I knew the inlet valve was working when direct wired to 120v. Switch did not have continuity. Replaced switch and inlet valve worked at start of cycle. Read more