Need Help?
Call or text
Show parts
Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.
Usually ships within 4 - 14 days
Fix a dishwasher that won't start or run because the door won't latch. This strike receiver allows the latch to engage and signal a closed door.
Seals the gap between tub and door to prevent water leaks. Replace if torn, frayed, or compressed. Confirm fit with your dishwasher model number.
10 - 16 x 3/8 , hex
This part is discontinued by the manufacturer and is no longer available for purchase.
Replacement dishrack roller for dishwashers. Attaches to the sides of the rack to allow smooth gliding movement. Replace when cracked, broken, or worn.
Set of 8 Torx screws and washers for mounting dishwasher tub rollers. Replace bent, stripped, or corroded fasteners when installing new rollers.
Fix ER/UO error codes with a new vent blower assembly. Solves steam venting issues and limescale buildup. DIY install in 5-10 minutes with video guide.
Trim bezel that frames and protects the vent opening on your dishwasher door or panel. Replace if cracked, broken, or missing to restore a clean look.
Replacement water inlet hose for dishwashers. Connects water supply to the tub. Replace if cracked, leaking, or damaged by pests or wear.
Flexible drain hose channels waste water from your dishwasher to the drain system. Replace if cracked, leaking, or damaged to prevent water backup issues.
Dishwasher won't fill with water? A faulty water level float switch prevents proper filling. This switch assembly typically takes 15 minutes to replace.
Fix a dishwasher that stops mid-cycle, overheats, or won't heat water. This thermostat regulates temperature during wash cycles. Moderate DIY repair.
Secures dishwasher thermostat to base for accurate temperature sensing. Replace if loose or broken to prevent overheating. Verify fit by model number.
Dishwasher door gasket foam creates a watertight seal to prevent leaks. Replace if you notice water escaping or the foam is compressed or torn.
Replace a damaged or frayed wire harness in your dishwasher. This internal wiring assembly connects electrical components and may need replacement if cracked or worn.
Replacement mounting screw for dishwasher panels and internal components. Needed when original screws are stripped, missing, or corroded during repairs.
Replacement mounting screw that secures control switches and switch assemblies to the dishwasher panel. Needed when original hardware is lost or stripped.
Replacement mounting screws that secure your cooktop to the countertop or cabinet. Essential when original screws are stripped, missing, or damaged during installation or service.
Replacement cabinet insulation panel for dishwashers. Installs inside cabinet to reduce heat transfer and noise. Needed when original is torn, compressed, or missing.
The Cabinet Seal Kit is an OEM replacement part for Frigidaire dishwashers. It is a kit that includes all the necessary rubber seals and gaskets to make sure a proper seal around the dishwasher door. The cabinet seals are designed to prevent water leakage and contain moisture and debris within the dishwasher. Causes of bad seals can include normal wear and tear over time, exposure to cleaning chemicals or detergents that degrade rubber seals, or damage due to improper installation. Symptoms of bad seals include:
This Frigidaire OEM replacement part is also compatible with Electrolux, Gibson, Kelvinator, and some Kenmore models.
Replaces missing, torn, or saturated sound-dampening insulation blanket for dishwashers. Wraps around tub to reduce noise and protect cabinetry.
Side mount kit for installing dishwashers in openings with granite countertops. Includes brackets and hardware to secure unit to cabinetry when top mounting isn't possible.
Prevents water from leaking at door corners in your dishwasher. Replace if you notice pooling water on the floor during cycles. Easy DIY install.