Parts for Maytag HYG2460AWW: 07 - Tumbler Parts

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.

Felt seal creates an airtight barrier between drum and bulkhead for efficient drying. Replace if worn, torn, or causing longer dry times and lint buildup.

Replacement screw that secures the handle to the oven door trim. Needed when original screw is stripped, rusted, lost, or damaged during handle replacement.

Get your dryer spinning smoothly again - install the Whirlpool 341241 OEM Drum Belt in minutes.

Why this belt?

• Exact factory spec: 92 ¼-inch length × ¼-inch width, 4 ribs / 3 grooves - built to Whirlpool standards, not a generic copy.
• Broad compatibility: Fits most Whirlpool-made dryers - Kenmore 110-series, Roper, Estate, Maytag, KitchenAid, Admiral, Crosley, Amana & more.
• Quiet, durable rubber: Reinforced EPDM resists cracking and stretch for years of reliable tumbling.

Fixes these common dryer problems

DIY install — about 15 minutes

1. Unplug dryer; remove lint screen housing & front panel.
2. Release belt tension at idler pulley; lift drum slightly to slide old belt off.
3. Loop new belt around drum, idler pulley and motor pulley (ribbed side down).
4. Re-assemble, run test cycle - enjoy quiet, consistent tumbling.

Rear support assembly stabilizes your dryer's housing and aligns internal components. Replace if cracked, broken, or worn to prevent noise and vibration.

Ground screw secures transmission housing and console components in washers. Replaces missing, stripped, or corroded screws. 10-24 x 3/8 inch fastener.

Washer making noise or parts wobbling? A worn retaining ring may need replacement. Secures gears and pulleys on shafts. Moderate DIY difficulty.

Made for most Admiral, Crosley, Norge, and Magic Chef dryers. Kit includes 2 drum support rollers, 2 support shafts, 4 screws, 2 spacers, 2 washers, 2 retaining rings and instruction sheet.