Control Board

Unplugged the stove. Removed the back of the control panel. Removed and replaced the membrane keyboard and the main PCB. Reassembled the stove and everything was back to normal. The PCB was probably ok but I wanted to be sure and get the stove working as soon as possible so I replaced both parts at the same Read more

I ordered the part from you and removed the damaged board and replaced it with the new board. It now works perfectly. I took all of about ten minutes. Thanks so much! Read more

Replaced the main control board on a Thermador oven model POD301J/01 after we got an E115 error and the top broiler would come on no matter what setting you put it on and wouldn't turn off and would overheat. Took me about 30 mins total to replace after taking pics to make sure everything went back as it was. So far so good and it's working again! Read more

After much reading on line regarding my problem. I decided to do any test that I could to try to diagnose and fix this myself if I could. This took a lot of time and patience to get the answers on how to go about this from "experts" as some of the info was contradictory. I was almost about to give up and buy a new washer with less electronic parts and buttons as advised by an honest appliance technician . I tried one more thing first which was to disconnect the lead wires connected to the MCU .... Read more

• Timer will not advance

I replaced the timer Read more

We started getting the F06 code when on the normal cycle it was time to Rinse/Spin, pointing to a speed/tachometer issue on the motor. After several attempts of unplugging from power and restarting the cycle it would eventually start working for the rest of the laundry session. The Whirlpool technician after a brief look on the underside determined it was the motor and had to be replaced, even tough all troubleshooting tests on the motor were ok. I insisted that the probability was much higher... Read more

Replaced the "Encoder Board". My GE Advantium control panel came of fairly easily. There was 2 screws on top to remove a vent director giving access to a single screw that held the control panel in place. Once I removed that screw, I had to slide the control panel upwards by about 1/2" before it came off. At this point, I took several photographs of the wire connections to make sure I could reassemble them correctly... there were many! After unplugging the wire harnesses and connections, I... Read more

Myself Read more

Walk into the kitchen on 21 Sep. Eight year old Frigidaire refrigerator appears to be short cycling, controls are nonfunctional. Unplug it for a few minutes, plug it back in, appears to return to normal function. Return to kitchen half hour 45 minutes later it's short cycling again. Panel has codes on it (S or 5 E CE, later that changes to S or 5 Y CE). Research of codes says replace main board and control board. Not sure where this main board is. 22 Sep call appliance repair. "Soonest... Read more

Replace the Mainboard control and push the start button. Read more

Ordered the electronic control board turns out that was not my problem called Appliance Parts for technical assistance and they suggested I order the Panel Control. Fixed my JennAir within thirty minutes. Packed up first parts a instructed by my return authorization, received credit for returned part. Wonderful experience with all at Appliance Parts. Read more

Replaced switch Read more

Bought new optic control boards, both the emitter and the receiver. The repair process was so simple. The KitchenAid repair tech came out to diagnose our issue. He was only going to come back and install a new emitter. They wanted a lot of money to do the repair. They were going to charge us $257 just for the part (emitter board). We bought both boards for $300 from AppliancePartsPros. We decided to replace both boards, because if one went bad the other might not be far behind. Read more

Replaced the control board. Read more

• Frost buildup