General Electric Touch Pad

Replaced the entire back splash, I would like to give kudos to AppliancePartsPro, the item was shipped in a timely manner Read more

Control ovn kit Read more

Replacing the control panel assembly is extremely easy with one exception. To take off the existing panel (and there is no way to order a button for this, you have to order and replace the entire assembly), you pull the dial knob off (it comes right off, no tools required). There's a single screw underneath, Phillips head. You can then slide the panel up, and then unplug the cable connecting the circuit board to the dryer itself. Next steps: Unscrew the half dozen or so screws to remove the... Read more

Order new pad and replaced old one Read more

Unplugged the dryer. Disconnected the exhaust hose w/ 5/16" nut driver. Removed all knobs. Removed 3 Phillips head screws behind the console. Removed all switches and controls by lifting locking tabs and turning counter clockwise. Installed switches and controls into new console by inserting into hole(s) and turning clockwise until locking tab engaged. Positioned console capture tabs back in their slots and snapped console back in place with the back plate. Re installed the tree screws. Re... Read more

Ordered the faceplate and just for insurance a new switch and know. The installation required a phillips screwdriver, a needle nose pliers, and about 10 minutes of time. Thanks to AppliancePartsPros for getting me the right parts asap...........George Read more

The entire control board was replaced. It was quick and easy! The entire repair took a total of 10 minutes, including testing. Be sure to order the new overlay, its permanently stuck to the face of the board. Read more

I unplugged the oven and then removed the back panel. Next I started started removing cables from the old control board one by one, being careful to plug them into the same place on the new board. There were some slight differences in where some cables were located, but the ports are labeled and you can just match it that way. Then I applied the new faceplate to the new control board. I unscrewed the old board and screwed in the new board. Very easy replacement. Read more

• Won't start

Literally took no more than 15 minutes. I unscrewed the back panel of the door, unplugged the old keypad and pealed off the old keypad. I used rubbing alcohol to thoroughly clean the surface where the new keypad would go. Then I slid the new keypad into place and plugged it in. Peal off the adhesive backing and stick the new keypad down, reattach the door panel and you are good to go. Read more

I replaced the Dispenser's Interface board assembly Read more

Replaced the dispenser control panel. Read more

Got on your web site, put in the model number and bingo a list of common problems was displayed. Clicked on the start button problem link and up came the suggested part. Your web site said that you had the part that I needed so next I clicked on the video that demonstrated how to replace the part. Ordered the part and selected next day air delivery. The next day the part arrived before 10:30am. Thirty minutes after opening the box, my GE Monogram Dishwashing was running like a Swiss... Read more

We updated a 'not so old' Biscuit GE Range to BLACK. It was easy to figure out what parts I needed by using the selection process on the web-site, I ordered parts then followed the pictures and videos provided to change out the handle, panel, drawer and knobs, I used two metal look back splash panels on the door to give it a rustic look and am very happy with the result. The range looks great in my newly remodeled kitchen Read more

I looked up the part numbers, ordered them from Appliance Parts Pro and they arrived the next day. Followed the video to replace the parts - it was super easy and now everything works great again! Saved lots of time and money. Read more