Generac Starter

This is a genuine OEM recoil starter assembly sourced directly from the manufacturer. It is designed for use on pressure washers. Recoil starters are comprised of a rope, pulley, and tension spring. When the rope is pulled, the tension spring is released from the pulley, and the crankshaft spins, starting the engine. If any component in the recoil starter assembly is broken or missing, the engine will not start. Often, it is simpler and quicker to replace the whole assembly than it is to take it completely apart to replace one component. Replacement takes less than ten minutes. Before starting, remove the spark plug to ensure the engine doesn't accidentally fire up. Use a screwdriver to remove the damaged recoil start assembly. Place the new assembly on the pressure washer and install the screw. Tighten the screw until it is snug, but do not overtighten. Reinstall the spark plug. Pull the rope to verify the pull start is installed correctly.This recoil starter assembly is made of durable black molded plastic with a nylon rope starter and high tensile metal recoil spring; it is sold as an individual unit. This recoil starter assembly is specially designed for 196cc engine pressure washers manufactured by Generac.

This replacement part is an electric start contactor assembly intended for use with generators. It is part of the generator's ignition system.A new electric start contactor assembly might be needed if the generator is unable to start or is struggling to start. If the start contactor is missing or damaged, the generator might be unable to start. It is common that this part might become worn down over time and should be replaced after years of normal wear and tear. Be sure the generator is powered down and cooled off before attempting to replace or repair this part. This is a genuine OEM replacement part manufactured by Generac. This part is sold individually.

This is a replacement recoil starter assembly for generators. To crank the engine of the generator, the user will need to pull the starter cord, which spins the flywheel and starts the engine. However, over time, the cord will wear and fray, eventually needing to be replaced. The exterior of the starter housing can also be damaged by rust or through impacts, and the internal spring can also fail. To replace the recoil starter assembly, users will need to first disconnect the spark plug. Next, remove the bolts holding the recoil starter assembly to the top of the engine. Lift away the assembly housing, including the inner cup, and then install the new housing by reversing these steps.This recoil starter assembly is a genuine OEM part. It is sold individually, and will fit several different Generac generator models.