Customer Questions and Answers for Washer Motor Control Board by Frigidaire

Hello Art. Based on the error code you provided, you will need to order and replace the control board 137007000NH on the unit.

Hello Paul, This is usually caused by debris in the drain in front of the drain pump. If you have already removed the hose between the drain pump and the outer tub and it is clear, you should check the drain pump impeller to ensure the impeller has not separated from the drain pump motor shaft. If this is good, the unit needs a diagnostic test run on it. This will pull fault codes and show what part of the unit will require attention. This is fully explained on the tech sheet found in the manila envelope in the base of the machine. The fault codes are also defined on this sheet.

Jose, With the unit having e56 error code, this would indicate a high motor current. You will want to check the following: 1. Remove the belt from the motor and spin the motor pulley. Does the motor spin free? No, replace the motor. Yes, go to step (3). 2. Spin the tub pulley. Does the tub spin free? No, check the tub bearings. Yes, go to step (3). 3. Disconnect the plug from the motor and measure the resistance of the windings (pin 1 to 2, pin 1 to 3, pin 2 to 3). All readings should be between 4 and 6 ohms. If readings are correct, replace the Speed Control Board. If readings are incorrect, replace the motor. If it is determined that the speed control board is faulty then the speed control is part number 134743500.

Jose, This control board 134743500 is the one that controls the motor speed. If you are having an issue with the unit not spinning at top speed you will first want to check the door latch assembly then using the tech sheet you will want to test the motor and the speed control board.

Jose, The speed control is what controls the speed of the motor from low or high. The main control will control all aspects of the unit.

Jose, The error code would be a e5e. This error code is a communication issue. Communication problem. Check the wiring between the Main Control Board and the Speed Control Board. Wiring bad, correct wiring problem. Wiring good, replace the Main Control Board. If the problem is not corrected, replace the Speed Control Board.

Hello Mark. You need to check the door lock assembly 131763256 and see if it is bad and will need to be replaced on the unit.

Hello Mitch. Most likely the lock assembly is the issue. However, if not, it is the main board, not the motor board that needs to be replaced.

Hello Aristides. No, there is no need to reset the controller on the unit.

Hello Jera. You will need to order and replace the lock assembly on the unit.