Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Rubber door boot seal prevents water leaks between the washer drum and door. Replace if torn, cracked, or leaking during cycles. Confirm fit by model.
I noticed the rubber seal (bellow) was damaged near the bottom of the bellow. It looks like removing clothes from the machine had worn away and eventually ripped away some of the seal. This caused water to leak out the bottom of the door. I looked up the model number of my washer on the web and searched for the part number of the bellow. Once I found it I searched eBay, Amazon and a few other places for the part number and opted for Appliance Parts Pros. The part was reasonably priced and... Read more
Washer won't drain or pump keeps running? This drain pump circulates and removes water during wash cycles. Common DIY repair, typically 15-30 minutes.
The original pump was getting jammed intermittently, more and more often. I cleaned it out, but that didn't help the jamming. So I ordered a new pump. Have your new pump on hand and look at it to see how it attaches. The original pump, a different part number than the replacement, lasted about 7 years of almost everyday use, with multiple loads each day. My washer model Maytag MHW5500FW0 has the pump at the bottom back, in an awkward position. This took me about 2 hours due to the awkward... Read more
Washer won't drain or spin? A failed water pump is often the cause. This pump circulates and drains water during wash cycles. DIY repair in 1-2 hours.
There was a loud noise from my washer during the drain cycle. (The washer seemed to drain just fine.) It was pretty easy to determine that the noise was coming from the drain pump. (Which for my washer is behind the front lower inspection panel on the right side front.) I inspected the outside of the pump for any physical damage and verified no issues with the pump or the mounts. Everything seemed ok. I then checked the drain pump filter(You will need something to catch water if you do... Read more
Replacement door hinge for front-load washers and dryers. Attaches door to cabinet for smooth opening and closing. Needed when hinge is cracked or worn.
I ordered the new hinge and the cap they said would be needed, took the door apart and installed new hinge. Only problem, wish they told me I needed 4 of the caps, for one hinge and each cap was 11.95 x 4...pretty spendy. Fortunately I was able to reuse 3 of my worn ones for now. Read more
Fix F03 E01 or F08 E01 error codes with a new water level pressure switch. Controls fill and drain cycles. Easy 5-minute DIY replacement for washers.
I contacted AppliancePartsPros and gave them my symptoms and failure codes and they were able to diagnose the problem and send the correct parts to resolve the issue. This is the 3rd or 4th time I've used their service since 2012 and they have been correct on each and every repair issue I've had. Many thanks for the professional advice and help! Read more
Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.
With the video that was made from appliance pro.Help me out one hundred percent to understand what I was dealing with Read more
Replace your washer door bellow seal if you notice water leaking from the front door or visible tears in the rubber. Confirms fit by model number.
I followed the very well made repair video for this particular part. The total time it took for the repair was under 20 minutes. But I have a suggestion for the repair video and that is to emphasize that when reinstalling boot. Have the tachnician point out that there are drain holes in the boot that need to be situated and reattached toward the bottom of the washer chassis. Unfortunately I had to redue and double the repair time because the wash water would not drain properly during wash... Read more
Flexible seal between washer door and drum that prevents leaks during operation. Replace if torn, cracked, bulging, moldy, or leaking. Confirm fit with your model number.
Replaced the bellow. Read more
Fix a washer door that won't lock or stay closed during cycles. This door latch assembly secures the door and allows cycles to start. DIY repair.
Did lots of internet research. Narrowed problem down to three things - door lock latch, control unit, and motor control unit. Figured out how to run the diagnostic test program, which showed a F22 (door lock) error. Removed and ohm tested the door lock (pins 1 & 3). Found door lock latch to be defective. ordered new one and installed it. YouTube video helped a lot. https://www.youtube.com/watch?v=_SjU6k5bpSs So far, so good. Have only done a few loads. New door lock latch tested fine. Read more
Hinge pin bushing for front-load washers. Provides a pivot point for the door hinge. Replace if worn, cracked, or causing the door to drop or sag.
Fix F06 E01/E02 error codes or washer that won't spin or fill. Direct plug-in replacement takes 30-45 minutes with basic tools. Includes video guide.
The washer would try to start. The door would lock, but then would get stuck in the phase of start-up where the drum needs to roll around (I assume so it knows what's in there). It would sit and think about it for a couple minutes and then give the error codes. I shut it off (sometimes had to unplug it and plug it back in), and it would take about 10 minutes for the door to unlock. After reading about fixes, I decided to dive in and try it (the washer is only 3 years old and I'm pretty... Read more
Broken or cracked dispenser drawer causing detergent leaks? Replace your washer's detergent drawer. Easy 90-second install, no tools needed.
Found the parts on appliance parts pros and ordered them. It was amazing one arrived the next day and the other just the day after that it was so quick! There wasn't any real assembly just pulled the old drawer out and put in the new one! Read more
Secures control knobs to the panel on washers and dryers. Replace if the clip is broken, missing, or worn, causing knobs to fall off or sit loose.
I purchased the lid latch assembly and the lid switch strike. Following the clear video instructions for each part, my handy teenage son was able to remove the lid latch assembly and replace it with the new part as well as the lid switch strike. The washer is back to working perfectly for under $100. Appliance Parts Pros carry the parts to repair and at a lower cost than other online retailers. I saved about $30 compared to the other online site and I saved a service call fee. I'm so glad I... Read more
Fixes door lock error codes (F5E3), door won't latch, or continuous lock cycling. DIY-friendly repair takes 20-30 minutes with basic tools.
We watched a YouTube video on how to replace the door latch. Very simple to do. We had to remove the metal band holding the door gasket to be able to access the latch. After removing the band, we pushed aside the gasket and removed the screws to the latch and the connecting cables. To install the new part, we just reversed the process. We reconnected the cables, inserted the new door latch and screwed it in. The hardest part of the process was getting the metal band around the gasket. It... Read more
Door won't latch or stay closed during wash? The door strike may be broken. Easy 5-minute DIY fix with just a screwdriver. Includes installation video.
I removed the two screws and all the pieces that were broken. Went online to Appliance parts.com, searched for the part using the model number from the machine and ordered the part . part arrived in 2 days and with a Phillips screwdriver was installed in less than 5 minutes. Read more
Fix F26 or F22 error codes and washer won't start issues. This door latch assembly ensures proper closure and signals wash cycle start. DIY-friendly repair.
First I check with Appliance Part Pros, watch videos how to access the parts I believe to be the problem. I love there videos and parts list of solutions to fix what it wrong. First I removed the washer from the laundry room and but it in the garage for more room to work on it. The next thing I replaced was the door lock which seem to be a possible cheap fix and does get a lot of abuse, however it was not the door lock and people should stop posting it could be this issue when they get a F06... Read more