Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Seals refrigerator door to prevent warm air entry and maintain temperature. Replace if cracked, torn, or doors won't close tightly. Verify fit by model.
I took the new seal out of it's packaging and used a blowdryer on low heat to soften up the seal so that the crease from shipping (it was folded to ship) disappeared. Next I took the refrigerator door off, removed the old seal, & cleaned the area where the new seal would be applied. Following the video on the Appliance Pro Parts website, I re-installed the new seal and put the door back on. Last step was to snap on the new hinge cap I ordered. The video online was easy to follow and this... Read more
Creates an airtight seal around your freezer door to maintain consistent temperatures and prevent cold air loss. Replace if torn, cracked, or loose.
Replaced Case Water Filter assembly DA81-05883A. Please read my post entirely before starting. I completed all the tasks that I could without having to disconnect the refrigerator since it was full of food. First I removed the panel on top of the refrigerator that covers the water line that feeds the dispenser. Do not disconnect any electrical connections or the water line at this time. Remove the panel from the back bottom of the refrigerator that covers the compressor and water valve,... Read more
Protective cover for the ice maker's infrared emitter sensor in the freezer compartment. Replace if cracked, broken, or missing to shield the sensor.
Followed the video you provided. Read more
Replacement cap that seals the water filter housing and attaches to filter cartridges. Needed when cap is cracked, broken, or missing notches prevent secure fit.
Replaced cap Read more
Water leaking from bottom of fridge? Cracked evaporator drip tray lets defrost water escape. Moderate DIY repair, about 45-60 minutes with our guide.
The drain pan (Tray-Evaporator Pan) was cracked in 2 places. We had to remove the front panel. Loosen the bracket that holds the water filter. Take off the back panel and disconnect the bracket that holds the selenoid. It was not necessary to unhook the water lines, just the bracket. It was not easy to remove the old pan and get the new one in, but holding the water filter, with the bracket intact, as far to the left side of the refrigerator as possible gave us the room to get the pan in. ... Read more
Secures the handle end cap to the center of your refrigerator door. Replace if missing, stripped, or lost during handle repairs. 8-18 x 1/2 inch size.
This was actually one of the easiest fixes I’ve done. All that was required was to remove 3 screws to remove the broken part. I used a pair of pliers to remove the moisture sensors from the broken part to the new one. Read more
Fix an ice maker that stopped working or leaks water into the bin. This ice mold tray replacement takes about 10-20 minutes with our step-by-step video.
I have a Whirlpool Side-by-side Model ED22PWXBW01. A year ago, the ice cubes started freezing together in the rear of the ice bin for no apparent reason. Although the problem started off small, it gradually grew much worse, and finally I could see water dripping out of the ice mold and into the bin during the fill cycle. Re-levelling the refrig didn’t help, nor did adjusting the cube size / fill level. With guidance from the video, I removed the icemaker from the wall of the freezer. The... Read more
Freezer icing up or refrigerator too warm? This defrost control board coordinates defrost cycles to prevent frost buildup. DIY-friendly 15-30 min repair.
Tried to put refrigerator in defrost mode and defrost would not initiate. Checked the bi-metal and heater, both tested good. Replaced the ADC board and refrigerator went in to defrost. problem solved. Read more
Fix a loose or wobbly dispenser paddle with this strain relief. Cushions the dispenser arm connection to prevent wear. Easy 5-minute repair with video guide.
With the help of the fantastic videos provided on the web site for each replacement part, it was extremely easy to complete the repair Read more
Refrigerator warm but freezer cold? Noisy evaporator fan? This mounting grommet reduces vibration and noise. Takes about 1 hour to replace with video guide.
I noticed Ice maker Quit for the third time in 15 years so I decided to buy another Ice maker, I installed it and NO ice still?? Well I went after the other problem thinking if it does not get cold enough maybe ice maker won’t work. I ordered Defrost Switch, Heater and Evaporator Fan just to be safe. I replaced all three, the fan was noisy, the heater OHM’d ok but I replaced it as did the defrost switch, I put it back together, the Freezer got to 0 degrees and the frig got to 38 degrees so I... Read more
Bottom mounting screw for refrigerator ice maker auger assembly. Secures auger blade components together. Replace if stripped, damaged, or missing.
Replaced the auger, blade and screw (bottom) Read more
Horizontal metal rod that secures glass shelf panels inside your refrigerator door. Replace if broken, bent, or missing to prevent shelf slippage.
Cut piece to fit Read more
Ice won't dispense or auger not turning? This drive shaft holder secures the ice maker shaft for proper rotation. Easy 10-minute DIY fix with video guide.
My refrigerator was not dispensing ice. I could hear the motor activating but noticed the ice auger was not turning. My old drive shaft was stripped on both ends. Video was very helpful and it was an easy fix for someone with little handyman experience. Received my order much faster than expected! The parts arrived the next day and paid for the standard shipping charge. I live in Texas. Read more
Lower door hinge kit for side-by-side refrigerators. Includes left and right hinges. Replace worn, cracked, or missing hinges to restore proper door swing.
Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot Read more
Wire shelf for refrigerator freezer compartments. Provides additional storage space for organizing frozen items. Replace if cracked, bent, or missing.
Very disappointed that WHIRLPOOL was too cheap to put enough shelving in the new refrigerator/freezer we just bought. Thankfully, I found an additional wire rack here at Appliance Parts Pros and it fit perfectly ! No problem to install, all you do is fit it into the slots in the freezer wall. Read more
Fix ice dispenser not working or auger not turning. This drive shaft sleeve connects the motor to the auger. Easy 5-10 minute DIY repair with video.
Added a new shaft as the old shaft had worn down...........works perfect now. Thank you Easy fix ....no more than 10 mins. Read more