Valve Parts

I replaced the door seal for the leak. We had a small tear in the sealing surface that resulted in water dripping down the front of the machine (just below the door). I also replaced the detergent dispenser main box with diverter unit. This corrected excessive water being left inside the detergent dispenser at the end of each cycle. I highly recommend replacing the dispenser seal and gasket nozzle to be on the safe side. As these parts are subject to wear and fatigue over the life of the... Read more

Watched a couple of videos that closely matched my project. Warranty company couldn't find a service tech in my area so they had to refund my stove purchase. Part cost under $50. Refund: $950!! Read more

I took apart my stove top and front burner assembly and changed out the part I ordered from you guys. Worked great and only cost me a fraction of the price of hiring a repair guy. Thanks a lot! Read more

Replaced the defective float switch. Read more

The repair is easy. Two screws in the back hold the top cover - once they are off you need to slide the cover back and it comes off. The valve is right there where the cold water hose is connected. Disconnect the control wires / clamp and slide back the wire clamps / remove the two rubber hosed / remove the old valve (it is snapped in place - look at the new one to understand the snap mechanism) / install the new valve. The repair takes less than 10 min. I tested and sure enough... now it... Read more

Removed some screws, opened the top of the wash machine, unplugged some wires to remove the part, plugged the wires back into the mew part, put the new water valve into place, secured the water valve with the screw, put the top back on the wash machine, and replaced all remaining screws! Real Simple! Read more

I found I could "rap" on my broiler/oven control valve and the oven would light, so I ordered a new control valve. Installing valve was not difficult except for having to lay on the floor and work in a small space. After installation, the oven lit only ONE time...and the boiler/oven problem was unchanged....broiler would light, but not oven. (Both incandescent pilots would glow brightly, so I did not suspect the igniter/pilot.) A friend suggested I swap ignitors anyway...and indeed, the... Read more

Replaced manifold Read more

Went to youtube and found out what was the cause. Replaced the parts that said might be the issue, Dryer working perfectly. All done in about 1/12 hrs Read more

Replaced water value, like a walk in the park. Read more

Replaced part, had a friend do it for me. I still can't believe the part was here as fast as it was, less than 24 hrs from time I ordered it. great service, thank you Read more

• No hot or cold water
• Will not stop filling with water

Replaced the solenoid controlled water valve. Read more

1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve. Parts $220 for Dishwasher Estimated Labor $400.00 Labor $0.00 Parts $100.00 for Pullout Faucet Estimated Labor $175.00 Labor $0.00 Read more

Needed to replace the water valve. Ordered the part Sunday afternoon and it arrived Tuesday morning. Installation was simple especially after watching the online repair video. The most difficult part of the installation process was moving the refrigerator out from its location in order to get access to the back. Read more

I replaced the water inlet valve. Apparently, the hard water in my house slowly deposits crud around the valves such at over time, the valve seals quit forming a tight seal when closing. This allows water to slowly leak through, even with the machine off. I removed the top of the washer, disconnected hoses and wires and replaced the valve in fairly short order. This fixed the problem. Read more