Parts for Maytag GDG512: 04 - Gas Valve Parts

By Maytag. This three coil kit is used on older Maytag, Admiral, Norge, and Jenn Air dryers. Includes three coils - 12001348, WP305604, WP305605.

One of three coils, to get all three order 12001348

Fix a dryer burner that starts then goes out with this gas valve coil. DIYers can test resistance with a multimeter and replace in under an hour.

Replacement mounting screw for washer panels, brackets, and components. Needed when original fastener is missing, stripped, or rusted to restore secure fit.

Specs: 10 - 16 x .375

Dryer won't heat or flame cycles on and off? A warped burner assembly prevents reliable ignition. Moderate DIY repair restores even drying.

Gas dryer not heating? A faulty igniter is the most common cause. This part ignites the gas burner to heat your dryer. DIY-friendly, installs in 30 minutes.

Dryer won't heat or flame shuts off after 15 seconds? Gas valve coils control gas flow to the burner. Takes about 30 minutes to replace both coils.

Dryer won't heat or flame shuts off after 15 seconds? Gas valve coils control gas flow to the burner. Takes about 30 minutes to replace both coils.

Dryer not heating or flame goes out after a minute? This gas valve with coils restores heat. 15-minute repair with video guidance available.

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.

Dryer won't heat or flame goes out after ignition? The flame sensor monitors burner flame presence. Common DIY fix with multimeter testing required.

Dryer won't heat or overheats? High limit thermostat prevents overheating by shutting off heat at high temps. Easy DIY repair with video guide.

Converting your dryer from LP to natural gas? This conversion kit includes the regulator limiter, orifice spud, and instructions. DIY install in under 1 hour.

If your dryer won't stay lit or shuts off after a few minutes, the gas limiter may be faulty. This regulator controls safe gas flow to the burner.

Converting your dryer from natural gas to propane? This LP conversion kit includes orifices and instructions for a safe switch. DIY in 30 minutes.