Search Results

Ordered Impeller and Shaft Seal Kit which came overnight. Easy to put in after watching the video. While installing I found that Inlet Sump was ripped and ordered the part which came overnight. Trickier to install but thought it went well. Even though Shaft Seal probably was not the problem it did need replacing. Got it put back together and water would come into the dishwasher but it would not start and pump the water to wash. Called Tech Support and got some answers but did not have time to... Read more

• Noisy
• Will not drain

I had previously disassemble the pump assembly to find what I at first thought was an oddly shaped spring, which it was. What I learned by researching the parts was that the spring's odd shape was a result of something having gotten caught in the pump and jamming the impeller. After ordering the parts, I watched the "repair video" a few time and proceeded to remove and replaced the affected parts. Reassembly went pretty much as described with the one small glitch being the seating of the new... Read more

• Will not tumble

This was a Maytag DE312 actually a Whirlpool labeled as Maytag) and is 27 years old. Replaced motor, drive belt and drum rollers. One tricky part was the motor because the new motor comes with integral starter and it was necessary to cut off existing female spade connectors on some wires and crimp on new connectors. Instructions were adequate but need to be carefully followed and a decent electrical stripping and crimping tool must be at hand. I bought a new motor drive pulley because another... Read more

Replace pump motor assembly. Read more

I replaced the belt and the pump. It now works like it is new again! I am glad that I purchased the belt installation tool. It made replacing the belt very easy. I also purchased the Control Assembly which I did not install. It wasn't needed to repair the washer but I will keep it in case it is needed for future repairs. Of the 3 different web sites I looked at, AppliancePartsPros was the best price and the parts were at my house in 2 days. I will use AppliancePartsPros again if and when I need... Read more

• Will not drain

Unscrewed the leaking filter and replaced with the new one. End of problem. Great service and prices at Appliance Parts Pros.com. This will be the first place I check whenever I need repair parts for any of our appliances in the future. Read more

My dishwasher was running super loud for several loads but appeared to be cleaning just fine. One day it went from super loud to hardly a sound at all, not even the sound of water. After finding this site I found others with similar issues and it pointed to the Circulation Motor. Normally I wouldn't feel comfortable with pulling the dishwasher out of it's slot and performing this type repair but after watching the video posted along side the pictures of the part it looked pretty easy so I took... Read more

First determined drain discharge hose was clear. Turned of power to dishwasher. I did not find it necessary to remove the dishwasher. I simply removed the lower service panel at the floor and was able to easily remove the defective pump, unplug it, replace the small rubber check valve flapper before the pump inlet and reinstall the new pump assembly. The dishwasher surprisingly cleans and runs quietly like new again although I found no excuse for the pump failure as it is well designed. Never... Read more

I opened the washer and replaced the pump. To open the washer: 1. Remove the 2 screws that are different from the others in the top back corners of the machine. That will let you remove the top. 2. Remove the soap tray and its holder. The tray comes out if you depress the tab in the back center. Its holder comes out if you remove the two screws in the front. You can leave all the hoses attached. 3. Remove the control panel. It snaps in. Undo the top snaps first. You'll have to reach... Read more

I ordered a new vario motor and a soap dispenser. I turned off the water and the breaker, disconnected the water line and the power at the front base of the unit, disconnected the drain hose from the garbage dispenser, and pulled out the dishwasher and laid it on a blanket on its face. I unscrewed and removed the plainly visible vario motor on the bottom of the machine and removed the cam from the shaft. I then used a needle nose plier to carefully turn the D-shaft on the new motor to exactly... Read more

• Won't start
• Noisy
• Will not drain

I fixed it by installing a ge pump and motor assembly. it works fine Read more

Ran diagnostics 5 times to make sure I get the same error code and then called Appliance Parts Pros to order the washer pump. They informed me they had the pump assembly that has multiple parts on the unit and it was cost effective to order the assembly. I ordered the assembly and after a long back order time received the part. I purchased the service manual and was using that as a guide, then found a real nice you tube link to replace the assembly made by Appliance Parts Pros. This is the link... Read more

Ended up with replacement of the motor assembly. Read more

• lights flashing or blinking
• Noisy

This was a 5 min job after I watched a video on YouTube Any one can do this Read more

First off I want to say Appliance Part Pros rock! I have used them for purchasing repair items for other appliances in the past, so when my washer started making weird noises this was my go to source. I thought my problem was likely pump motor related as the water wasn't draining and I could hear the sound of the pump trying to work. After reviewing what others who had similar situations found to be the problem I took a gamble and decided to get the drain pump. Some who had that problem... Read more

I think I could have just replaced the pump, but I chose to replace the whole assembly. The part is more expensive, but all the gaskets, etc, that come with it are new and that made sense to change all at once. I was able to change this in about 30 minutes, without removing the washer from the under-counter space. I did remove the front door panel, but in retrospect that was unnecessary and probably cost me more time than it saved. Empty the washer of parts, remove the front access panel.... Read more