Parts for Whirlpool 4GWTW4740YQ3: 02 - Top And Cabinet Parts

Replacement 27-inch top panel for laundry centers. Restores a finished cover for the cabinet after damage or wear. Protects internal components.

Replaces cracked, worn, or missing washer lid bumpers. Cushions lid closure and reduces vibration. Sold individually. Installation video available.

Fix washer control issues with this switch mounting screw. Secures cycle selector switch in console for reliable function. Simple DIY fix in minutes.

Right-hand lid hinge for washer tops. Replaces worn, rusted, or broken hinges that cause lids to sag or not open smoothly. Direct fit replacement.

Secures the washer lid to the hinge assembly. Replace if stripped, rusted, or missing. Essential for proper lid alignment and secure closure during use.

Washer won't start because lid won't lock? This lid latch strike secures the washer lid during operation. Simple DIY fix in under 30 minutes.

Factory mounting screw secures panels, brackets, and internal components in washers. Replace missing, stripped, or corroded fasteners for proper alignment.

Cracked bleach dispenser leaking onto your washer? This cup holds and meters bleach during wash cycles. Simple snap-in installation, video included.

Plastic trim bezel that mounts around the lid lock on your top-load washer's panel. Replace if cracked, broken, or missing to restore a clean finish.

Replaces broken or worn washer lid hinge bearings. Installs in the lid hinge assembly to allow smooth opening and closing. Needed when bearing is cracked or missing.

Secures wiring harness to washer top panel. Replace this clip if original is broken, missing, or no longer holding wires firmly in place during operation.

Fixes washer that won't spin or stops mid-cycle. This lid lock assembly secures the lid and signals the control to restore safe spin operation.

Replacement screw for securing panels, brackets, and internal components. Replaces missing, stripped, or damaged fasteners to restore proper fit.

Main outer cabinet housing for washers. Replaces cracked, dented, or damaged exterior panels. Provides structural support and finished appearance.

Replacement cabinet support brace that reinforces your laundry center's internal structure. Needed when the original is cracked, bent, or missing.

Hex head screw for trash compactor assembly. Replaces lost, stripped, or damaged screws during repairs. Essential hardware for securing components.

Secures wiring bundles inside your microwave. Replace this wire tie if it's cracked, broken, or missing to keep internal wires organized and secure.

Adjustable leveling leg threads into the washer base to support and stabilize the unit. Replace if cracked, stripped, or missing to level cabinet.

Secures washer hoses and prevents leaks by maintaining consistent pressure. Replace if you notice water leaks or loose connections. Verify fit with your model.

Secures U-shaped drain hoses or heating elements in washers. Replace if cracked, broken, or missing to prevent hose movement and potential leaks.

Molded protective cover that shields wiring from heat and abrasion in laundry centers. Replace if cracked, broken, or missing to protect wires safely.

Secures the rear bulkhead to the washer tub, reducing vibrations. Replace if damaged by water exposure, stripped threads, or rusted from age.

Flexible tube that drains used water from your washer tub to the standpipe. Replace if cracked, leaking at connections, or torn along the length.