Parts for Whirlpool LT4900XSW1: 11 - Brake, Clutch, Gearcase, Motor And Pump Parts

Washer won't spin or makes grinding noise during spin cycle? The basket drive rotates the wash basket. Moderate DIY repair with video guidance available.

Washer won't spin or spins slowly? This spin tube thrust washer creates a seal around the agitator shaft for proper spinning. Moderate 2-hour repair.

Washer won't spin or leaves clothes wet? This clutch retaining clip secures the clutch assembly for proper transmission engagement. DIY repair.

Secures the door boot seal on front load washers to prevent water leaks. Replace if seal is loose or water seeps during wash cycles. Confirm fit with your model.

Washer won't spin or leaves clothes soaking wet? A worn clutch assembly prevents the tub from spinning properly. Moderate DIY repair with video guide.

Clutch band and lining kit transfers motor power to the drum during spin cycle. Replace if washer spins slowly or won't spin. Verify fit by model number.

Clutch band and lining kit transfers motor power to the drum during spin cycle. Replace if washer spins slowly or won't spin. Verify fit by model number.

Washer won't spin or makes noise during spin? This clutch spring cap maintains proper tension in the drive assembly. Quick 5-minute DIY repair.

Fix a washer that won't spin or agitate with a new transmission. Common symptoms include loud clunking noises or clothes staying wet after cycles.

Washer making grinding noises or not spinning? This motor mount plate secures the drive motor to the gear case, preventing movement and vibration.

Secures panels or brackets in your laundry center to prevent vibration noise. Replace missing, stripped, or worn screws to restore a tight fit.

Washer won't spin or agitate? A broken motor coupling disconnects the motor from the transmission. DIY repair in 30-45 minutes with basic tools.

Washer won't spin or agitate? A faulty direct drive motor often causes spinning failure and burning smells. Moderate DIY repair in under 2 hours.

Washer motor shield deflects water, lint, and debris away from the drive motor. Replace if cracked or missing to prevent motor damage. Simple install.

Grey rubber bumper for washers. Replaces worn, cracked, or missing bumpers that cushion the drum or cabinet. Installs on various washer models.

Washer leaking water underneath or not draining? This drain pump removes water during the cycle. DIY repair typically takes 10-15 minutes with basic tools.

Secures the drain pump to the motor in direct drive washers. Replace if cracked, broken, bent, or missing to properly mount the pump and prevent misalignment.

Installation instructions included.

Rubber grommet that cushions the motor mount stud on your washer. Replace if cracked, worn, or missing to properly secure the motor to the mounting plate.

Secures the motor to its mounting point in your laundry center. Replace if the retainer is worn, broken, or has lost tension to prevent motor misalignment.

Secures panels and components in place. Replace this fastener if stripped, corroded, or missing to restore proper alignment and eliminate rattling.