Kenmore Washer 110.26432501 (11026432501, 110 26432501) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W11095997
Seals the washer shaft to prevent water leaks from the tub during wash cycles. Replace if you notice water pooling under your machine. Verify fit.
Do-It-Yourself Stories from Customers like You
Agitator would not work David W. • Murfreesboro , TN • November 19, 2014
Used the parts and youtube video from your company.
Read more
More
$22.95
- Compare At:
-
$27.31
- You Save:
-
$4.36
Genuine Whirlpool part
By: Whirlpool
Part Number: 285244
Rear leveling leg for washers. Adjusts height to balance and stabilize your washer on uneven floors. Replace if broken, worn, or rubber coating is damaged.
Do-It-Yourself Stories from Customers like You
Washing machine shook terribly Edward L. • Temecula , CA • August 09, 2015
Replace front legs and rear legs took about 30 minutes. Made sure rear legs had lithium grease applied ran a load of wash very little Vibration nothing compared to before legs were installed and balanced the machine with a level.
Read more
More
$22.41
- Compare At:
-
$26.67
- You Save:
-
$4.26
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10080230
Washer won't spin or leaves clothes wet? This clutch retaining clip secures the clutch assembly for proper transmission engagement. DIY repair.
Do-It-Yourself Stories from Customers like You
Sometimes it would spin other times it would not, agitated fine Laurence O. • O'fallon , IL • November 03, 2018
Replaced transmission (that was the problem) and clutch (if you're going to tear it down put in a new clutch - they're cheap). APPRO's video was a big help. Everything went as they showed except transmission does not just slide out. You have to work it in and out several times. Once it breaks free it will slip out. This was my first transmission. It was not nearly as hard as I had thought it would be.
Read more
More
$7.78
- Compare At:
-
$9.34
- You Save:
-
$1.56
Genuine Whirlpool part
By: Whirlpool
Part Number: WP308685
Screw secures appliance panels and access covers. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattles or gaps.
Do-It-Yourself Stories from Customers like You
Under the counter mounting brackets were missing Douglas A. • Glen Allen , VA • June 19, 2019
After several attempts at Local Hardware stores and Lowe's and Home Depot to find them I called AppiancePartsPros.com. I gave them the model number and what I was looking for and customer service directed me to the part on the Web site. They were extremely helpful and it was very fast and I got the parts the next day.
Read more
More
$7.95
- Compare At:
-
$9.38
- You Save:
-
$1.43
Genuine Whirlpool part
By: Whirlpool
Part Number: W10337780
Washer overfilling or not filling correctly? This water level pressure switch kit fixes fill issues. Includes switch, tube, and clamp. Easy DIY repair.
This part fixes the following symptoms
-
Will not stop filling with water
-
Will not fill with water
See more...
Do-It-Yourself Stories from Customers like You
Washer overfilling David C. • Pine Mtn. Club , CA • May 09, 2014
Reviewed troubleshooting tips and identified problem as "water level switch".
Watched repair video, which was very helpful.
Ordered part on a Sunday, which arrived the following Tuesday.
Repair was easy the fix was successful.
Read more
More
$56.95
- Compare At:
-
$67.20
- You Save:
-
$10.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP63134
Fixes loud humming or rattling noise during agitation. This dampening ring cushions the brake housing to reduce vibration. 45-minute repair with video.
Do-It-Yourself Stories from Customers like You
Our washer quit spinning Howard H. • Walton , KS • November 16, 2015
I did some research to diagnose the problem.After watching the videos I determined it needed
a clutch kit. I didn't know the first thing about washing machines,but I ordered the parts and with
the provided video,it was a piece of cake. Our washer works great now!
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: WP90767
Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.
Do-It-Yourself Stories from Customers like You
Certain buttons were'not working Brent T. • Easton , MD • November 17, 2014
One day my wife went to bake something and the bake/broil buttons as well as #3, #9, and oven light ceased to work. Local repair guy came by and wanted to charge $500 to fix it....YEAH RIGHT! Did a little homework and found this website, spoke with knowledgable staff who pointed me in the right direction. Took me all of about 20 minutes to install new control panel..everything works perfect...THANKS!
p.s. In doing my research come to find Maytag did little to insulate control panel from oven...
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Genuine Whirlpool part
By: Whirlpool
Part Number: 350572
Lubricates transmission gears for smooth wash and spin cycles. Replace when degraded or after transmission repairs. Verify compatibility with your model.
Do-It-Yourself Stories from Customers like You
Teeth stripped from gear in transmission Robert G. • Wentzville , MO • June 17, 2015
The parts I purchased from Appliance Parts Pro fit perfectly and were reasonably priced. I received them the next day, which made the Wife (and me) very happy. Although Appliance Parts Pro did not have a repair video for this, I was able to find one online and the machine is washing like new again. The website is well laid out and easy to find what your looking for. Between the available parts and the videos they provide, anyone who is reasonably handy should be able to repair their machine as...
Read more
More
$49.21
- Compare At:
-
$58.56
- You Save:
-
$9.35
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3363661
Supports the driven cam for smooth rotation in your washer's agitator mechanism. Replace if worn, cracked, or binding to restore quiet operation. Confirm fit.
Do-It-Yourself Stories from Customers like You
Washing machine agitator would not engage and wash clothes properly Mike C. • Sterling , MA • March 04, 2016
I replaced the thrust washer , agitator and agitator dog assembly.
The repair took about 10 mins after watching the repair video.
All works fine.
Mike C
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10119828
Secures the washer lid to the hinge assembly. Replace if stripped, rusted, or missing. Essential for proper lid alignment and secure closure during use.
Do-It-Yourself Stories from Customers like You
Whirlpool cabrio washer cracked lid (model wtw7800xw2) Mike M. • West Hartford , CT • November 29, 2016
I just replaced the glass lid and broken plastic frame with the all metal one.
Call 877 477 7278 for appliancepartspros and order the following Whirlpool parts (prices as of November 2016):
1 lid part number WP8572026 (AP6013408) for $119.81
2 hinges WP8563964 (AP6004844) for $6.17 each
4 screws WPW10119828 (AP6015313) for $1.97 each
Total $140.03 plus $8.95 shipping, grand total $148.98
Note that it does not say that this lid will fit model 7800, but the lid will fit this model. The...
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP353244
Washer overfilling or not filling properly? A damaged pressure switch hose prevents accurate water level sensing. Easy 15-minute DIY fix with video.
Do-It-Yourself Stories from Customers like You
My kenmore washer model 11029828801 was agitating during the fill cycle and the tub would only partially fill also at the end of the spin cycle rinse water was spraying in resoaking the clothes Jay S. • Hammond , IN • February 07, 2017
I read the FAQ section of Appliance Pros parts web site. I found out I needed to replace the temperature control switch, WPW10248240, to correct my problem. This switch also controls the tub filling water level based on air pressure via the attached vinyl tubing. I ordered the switch and the tubing, WP353255, in case mine was no longer any good, and I also ordered the retaining clips for the control cabinet, (2) of WP8312709, because they can be damaged when accessing the controls. My new...
Read more
More
$47.95
- Compare At:
-
$57.06
- You Save:
-
$9.11
Genuine Whirlpool part
By: Whirlpool
Part Number: WP387240
Replace a cracked, leaking, or worn balance ring on your washer. Attaches to the spin basket to stabilize the drum and reduce vibration during spin cycles.
Do-It-Yourself Stories from Customers like You
Washing machine would shake so bad during the spin cycle that it would move about a foot Charles L. • Arroyo Grande , CA • April 17, 2017
I first checked to make sure the washer was level. The washer is on a concrete floor. After watching lots of you tube videos I ordered all the parts that could be causing this problem. I ordered: Balance Ring, Suspension Pad Kit (3 rectangle plastic wear pads), Tub Suspension Pads(3 curved plastic wear pads), Suspension Spring, and a Spanner Wrench tool. After getting the washer apart it was obvious that the problem was the Tub Suspension Pads they had completely worn away so that only the...
Read more
More
$79.56
- Compare At:
-
$94.68
- You Save:
-
$15.12
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8312709
Secures the control console to the top panel of your dryer. Replace this clip if it's broken, cracked, or missing to keep the console firmly mounted.
Do-It-Yourself Stories from Customers like You
My kenmore washer model 11029828801 was agitating during the fill cycle and the tub would only partially fill also at the end of the spin cycle rinse water was spraying in resoaking the clothes Jay S. • Hammond , IN • February 07, 2017
I read the FAQ section of Appliance Pros parts web site. I found out I needed to replace the temperature control switch, WPW10248240, to correct my problem. This switch also controls the tub filling water level based on air pressure via the attached vinyl tubing. I ordered the switch and the tubing, WP353255, in case mine was no longer any good, and I also ordered the retaining clips for the control cabinet, (2) of WP8312709, because they can be damaged when accessing the controls. My new...
Read more
More
$18.95
- Compare At:
-
$22.36
- You Save:
-
$3.41
Genuine Whirlpool part
By: Whirlpool
Part Number: 285438
Washer won't stop spinning smoothly or makes loud jerking noise when stopping? The brake shoe stops the tub during spin cycles. DIY repair in 1-2 hours.
Do-It-Yourself Stories from Customers like You
No spin every thing else worked made high speed ticking noise Anthony D. • Follansbee , WV • May 12, 2015
First I looked at the many you tube vids, and there are many. appliance parts pros pretty much shows you how to deal with the parts. I changed the brake shoes and the clutch assembly which also comes with the driver cam. I also changed the metal brake operating cam. I think that brake lockup or improper brake release was the problem that broke the plastic cam driver. This was the broken plastic part making all the ticking noise. I first changed the coupling on the motor but that wasn't bad. in...
Read more
More
$91.39
- Compare At:
-
$108.75
- You Save:
-
$17.36
Genuine Whirlpool part
By: Whirlpool
Part Number: WP9724509
Replaces cracked, worn, or missing washer lid bumpers. Cushions lid closure and reduces vibration. Sold individually. Installation video available.
Do-It-Yourself Stories from Customers like You
Water pump after 18 years wore thru the pvc housing causing a pin hole leak James B. • Palomar Mountain , CA • April 13, 2014
Found AppliancePartsPros on-line. Sent us the manual, parts list, etc. via .pdf files. Our local guy did not. Had parts in stock, two day shipping, totally painless. The parts were approximately 1/2 the price the local guy wanted. OEM parts. Perfect fit on replacement. The Whirlpool is so well made, it was very easy to repair. It has several items, over the years, which failed. In all cases, repair was painless with a few common hand tools and a tad of patience. AppliancePartsPros had...
Read more
More
$8.36
- Compare At:
-
$10.03
- You Save:
-
$1.67
Genuine Whirlpool part
By: Whirlpool
Part Number: WP62780
Fix washer rattling noise or loose cabinet with this retaining clip. Secures cabinet to back panel. Easy snap-in installation takes 10 minutes or less.
Do-It-Yourself Stories from Customers like You
Washing machine wouldn't spin Alyne K. • Kaunakakai , HI • May 01, 2015
After looking at several YouTube videos, we decided we could attempt to fix this ourselves. We found the easiest video to follow from Appliance Parts, and ordered the clips and lid switch assembly (the clips we had to replace because we goofed that one ourselves). The parts came within a couple of days. The repair took a little over 1/2 hour only because we had to re-do some steps because my husband was over anxious and did some things without reviewing the video. Overall, it was a very...
Read more
More
$5.95
- Compare At:
-
$7.14
- You Save:
-
$1.19