Refrigerator Gasket & Seal

This door gasket seals the refrigerator compartment to help maintain proper temperature and energy efficiency. It replaces a worn or damaged seal so cold air stays inside and warm, humid air stays out. What it does:

• Creates an airtight seal around the refrigerator door to reduce temperature fluctuations
• Helps prevent frost build-up and condensation by keeping warm air from entering
• Supports consistent cooling performance and helps reduce energy use
• Commonly replaced when the seal is cracked, torn, flattened, or no longer closes tightly

• Designed for direct replacement; fit by comparing part to the existing gasket before installation
• Clean the door flange and remove old gasket adhesive/residue for best seal
• Work slowly around corners to seat the gasket evenly; heat (hair dryer) may help soften stiffer gaskets for fitting
• Disconnect power if required by your model before performing any repairs and follow all safety instructions in your appliance manual

This adhesive-backed foam sealing strip provides a simple replacement to seal small gaps and cushion contact points on appliance doors and panels, helping reduce drafts, moisture intrusion, and rattling. What it does:

• Seals small gaps around doors, panels or assemblies to help limit air and moisture transfer and reduce condensation
• Cushions surfaces to minimize vibration and rattling noises
• Helps improve temperature retention by closing unintended openings
• Commonly replaced when foam is torn, compressed, detached, or causing drafts

• Verify the mounting surface is clean, dry and free of grease or old adhesive before applying
• Measure and trim the strip to fit; peel back adhesive liner and press firmly along the full length
• Avoid stretching the foam during installation for best seal and adhesion
• If adhesion is poor, remove residue and consider using a manufacturer-approved adhesive

This is a replacement gasket for the refrigerator pan/vegetable drawer frame that helps restore a proper seal around the produce drawer to reduce air exchange and help maintain stored-food freshness. Fits the pan/frame channel for a direct OEM-style replacement. What it does:

• Seals the vegetable/crisper pan area to limit warm or moist air from entering the drawer
• Helps reduce excess condensation and premature spoilage of produce
• Restores proper drawer fit and alignment when the original gasket is worn or damaged
• Can stop minor air leaks around the pan frame that contribute to uneven cooling

• One replacement gasket for the pan/vegetable frame

• Remove the drawer and any clips or screws securing the frame before replacing the gasket
• Clean the mating channel of debris and old adhesive/sealant before installing the new gasket
• Press the gasket evenly into the frame channel; work around the perimeter to ensure a full seat
• Unplug the refrigerator or turn off power before starting