Thermador Parts

This was to address an E:09 fault code on a Bosch dishwasher. I swapped out the Circulation motor and heater assembly. The video given on APP.com was for a different model, but more or less the same. The video gave me confidence enough to order the part and attempt it. The significant difference was that in the video, the assembly is easily accessible from the bottom of the unit. On my unit, however, the bottom is a closed plastic pan that isn't easily removable, likely requiring removal of the... Read more

Leak was slow but becoming gradually worse. Pulled dishwasher out from under counter then visually inspected sump while it ran. As soon as the water got very hot, I could see the sump leaking where it meets the stainless pan. Searched for the correct sump gasket without success. Turns out that the gasket is built into the sump for this model. The built-in gasket is very narrow (under-engineered IMHO which is probably why it developed a leak). Thanks to Simon's excellent videos at... Read more

• Frost buildup
• Freezer not defrosting
• Freezer section too warm
• Fridge too warm

Condenser was encased in solid block of ice due to automatic defrost not working. Replaced thermostat and ADC control board. Working fine now. Most tedious part was using a heat gun to melt all the ice off the condenser coils. You will need a couple small wire nuts to splice the new thermostat into the existing harness (they are not included). Service tech wanted over $400 to repair, fixed it myself for half that. Thanks ! Read more

We replaced the black door seal gasket around the front of the dishwasher. The old black seal gasket had begun to deteriorate, every time it was touched black stuff would rub off onto hands and onto utensils in the upper basket. We wore some disposable gloves to remove the old seal to avoid getting the black stuff on our hands. Before entirely removing the old seal gasket we studied its placement to tell which way the new seal gasket should be placed. We didn’t want to place the seal gasket... Read more

I spent a lot of time taking apart and cleaning the drain pump and hoses in my Bosch dishwasher. I still got the error that the drain pump wasn't right. So, after doing some research, I learned that the motor might be done and that seemed to be the only solution. I serached for my part on APPs.com and found the part for about $43 ($50 by the time tax and shipping was added in). The part was ordered, shipped and was on my doorstep in two days. I followed the repair video instructions provided... Read more

Replaced both the Spray Arm and the Spray Arm Water Supply Tube. Highly recommend replacing base plate whenever the Spray Arm Water Supply Tube is replaced. Plastic tabs on the base plate hold those parts together and are likely to break (as seen on Appliance Parts Pros installation video!!!). I sensed tab weakness so just transferred parts needed from the new tube to the old tube and reinstalled the original tube / base plate assembly rather than risk breaking those plastic tabs. I should... Read more

• overflowing

After first thinking I had a leak under my sink (dripping into my workshop in the basement), I quickly traced the source back to my Bosch dishwasher. I removed the bottom kick plate (phillips screwdriver) and could see a continuous drip from the Water Inlet Valve. Easy to see because the Water Inlet Valve is mounted in front. I shut off the power to the dishwasher at my breaker box and turned off the water to the dishwasher. First, I easily disconnected the power clip at the back of the Water... Read more

We replaced the black door seal gasket around the front of the dishwasher. The old black seal gasket had begun to deteriorate, every time it was touched black stuff would rub off onto hands and onto utensils in the upper basket. We wore some disposable gloves to remove the old seal to avoid getting the black stuff on our hands. Before entirely removing the old seal gasket we studied its placement to tell which way the new seal gasket should be placed. We didn’t want to place the seal gasket... Read more

Popped on the new one, very easy Read more

Obtained a replacement hose from App Parts Pros. Was actually an easy fix. The old hose is detached from the housing by just pulling it out(there are no clamps) with the assist of a screwdriver for leverage. The new hose then plugs in. Voila! Read more

Originally the dryer was squeaking a lot, so I purchased a new belt tensioner, but the original tensioner was an old-style no wheel tensioner, so that wasn't the source of the squeaking. I saw a lot of lint had built up inside the unit where there shouldn't have been that much. So I viewed a few videos on the Appliance Pros site and saw that the rear wheel guides were the cause of the squeaking and the rear felt drum and blower housing seal needed to be replaced. The rear blower housing was... Read more

Ordered a new filter. Read more

• Ice maker won't dispense ice
• Ice maker not making ice

After finding out the cost that we would have to pay for the repair locally, I went to Appliance parts pro.com. with the intention of finding out the cost for parts. We had been quoted $100 for the first hour which included repair if it could be done under the first hour plus parts. And they added that the typical repair for the ice maker was between $200 and $500. Fortunately we are very organized and had the original paperwork of the refrigerator which has all parts and numbers for the... Read more

I bought the door and bottom seal and was already to go. Appliance Pro got the parts to me in 2 days. I read an article that said if the spray arm holes are blocked that this could cause a wave in the dishwasher that could cause the water to fly up to the inlet used for drying and the water could run down between the front and inside door appearing to be a leak. I checked and my spray arms were indeed blocked. I pulled them out, cleaned them up, reinstalled, and low and behold that was appeared... Read more

• Ice maker dispenses too little ice
• Not dispensing water
• Touchpad does not respond
• Leaking

I'm such a pro, I figured I needed a new hose for my water dispenser so I ordered it. When it arrived I called my handyman. He told me I did not need a hose I needed A cartridge. So I had to return the hose and order the cartridge! Your company was so cooperative and made the return so easy Thank you! Next time I call the handyman first! Read more

My refrigerator was not dispensing ice. I could hear the motor activating but noticed the ice auger was not turning. My old drive shaft was stripped on both ends. Video was very helpful and it was an easy fix for someone with little handyman experience. Received my order much faster than expected! The parts arrived the next day and paid for the standard shipping charge. I live in Texas. Read more