Frigidaire Handle

The Frigidaire handle and latch assembly is an OEM replacement part responsible for securing and latching the dishwasher door when it is closed for a wash cycle. This part is typically located on the front panel of the dishwasher, near the top of the door. It ensures that the dishwasher door remains securely closed during operation, preventing water and steam from escaping the interior.

Causes of a bad handle and latch assembly can include repeated use leading to wear and tear, accidental damage from forceful closing or opening, or internal mechanical failures. If the assembly is compromised, the dishwasher may not start, or it could leak during cycles.

Symptoms of a bad handle and latch assembly include:

• Difficulty in opening or closing the dishwasher door
• The door not latching properly
• The dishwasher not starting or pausing mid-cycle
• Water leakage from the door during operation

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This replacement latch secures the door closed so the appliance can operate correctly. Restores a positive close and consistent door recognition to help prevent no-starts and intermittent operation. What it does / common symptoms:

• Engages the strike to hold the door/panel closed
• Ensures the door-closed signal is made so controls can run
• Worn or broken latch may cause the door not to stay shut
• Unit may not start, show a "door" message, or stop if the door is bumped

• 1 latch

• Disconnect power before servicing; turn off water supply if applicable
• Access the latch per model—typically behind the front panel or inner door liner
• Note and transfer any springs/clips from the original latch to the new one
• Verify smooth open/close and proper strike engagement before testing operation

Color: Bisque

This replacement handle set restores a secure, functional grip to refrigerator doors so you can open and close them easily and safely. It matches OEM fit and appearance for a clean, factory look. What it does

• Replaces cracked, broken, or loose refrigerator door handles
• Provides a solid grip for opening and closing doors smoothly
• Restores proper alignment and user operation when original handles are damaged
• Helps prevent door damage and potential sealing issues caused by compromised handles

• High-level install: remove door trim/fasteners, swap old handle pieces for the new set, and resecure per your model's service sheet
• Use hand tools only unless the model requires otherwise; avoid over-tightening fasteners
• Disconnect power only if working near electrical components or lights; typically not required for exterior handle replacement

This door handle in bisque replaces a worn or broken refrigerator door handle to restore a secure grip and clean appearance. It matches the original style and finish for a seamless look. What it does:

• Provides a sturdy grip for opening and closing the refrigerator door.
• Replaces cracked, loose, or cosmetically damaged handles.
• Restores proper door operation by giving a secure, ergonomic hold.
• Matches the original bisque finish to maintain appliance appearance.

• One bisque door handle.

• Basic hand tools are typically required; refer to your model's service instructions.
• Handle attaches with screws or clips located under trim or behind the gasket—retain all fasteners.
• Work with the door empty or supported to avoid damage; keep parts organized for reassembly.